Can some USB, microcontroller expert advise me how can a USB webcam be interfaced with a microcontroller (PIC, ATMega, etc) so that we can...
Can some USB, microcontroller expert advise me how can a USB webcam be interfaced with a microcontroller (PIC, ATMega, etc) so that we can capture image frames (low speed, low res) with the microcontroller?
Microchip has introduced - get this, gang - a 6-PIN MICROCONTROLLER!It's got some flash, and a comparator. You can examine it...
Microchip has introduced - get this, gang - a 6-PIN MICROCONTROLLER!It's got some flash, and a comparator. You can examine it here:http://microcontroller.com/news/Microchip_PIC10F.asp- Bill Giovino Executive Editor http://Microcontroller.com
Hello Everyone,I recently inherited a design based on Infineon C167 microcontrollerwith Rigel Reads 3.1 software to program it. I have never...
Hello Everyone,I recently inherited a design based on Infineon C167 microcontrollerwith Rigel Reads 3.1 software to program it. I have never done anymicrocontroller programming before and since this doesnt seem to bevery popular microcontroller, there is not much I could find on thenet. There were a couple of books on it but I believe they are ingerman only. However I have to work on i...
DualCore has introduced a monster - two ARMs, two 10/100 Ethernet MACs, and a whole lotmore on one...
DualCore has introduced a monster - two ARMs, two 10/100 Ethernet MACs, and a whole lotmore on one microcontroller:http://microcontroller.com/news/dualcore_DCIC9907.aspNot a bad start for a startup, huh?Regards,Bill GiovinoExecutive Editorhttp://Microcontroller.com
Hi everybody,I've used till now a C167CR (high end microcontroller, Infineon ...)and I'm trying to switch to the ARM based...
Hi everybody,I've used till now a C167CR (high end microcontroller, Infineon ...)and I'm trying to switch to the ARM based microcontroller.Has somebody experience with C167CR and could me recommend some similarand suitable ARM-Based microcontroller.
STMicroelectronics has introduced the STM8 8-bit low power microcontroller.http://microcontroller.com/news/STM8.aspIt is software...
STMicroelectronics has introduced the STM8 8-bit low power microcontroller.http://microcontroller.com/news/STM8.aspIt is software compatible with ST's ST7 and offers better than 10x the performance.It can run at anywhere from 1.6V to 5.0V supply current.Bill GiovinoExecutive Editorhttp://Microcontroller.com
http://microcontroller.com/news/Rabbit_6000.aspSupports 802.11 a/b/g ON-CHIP, and runs at 200MHzArticle contains a block diagram.Bill...
http://microcontroller.com/news/Rabbit_6000.aspSupports 802.11 a/b/g ON-CHIP, and runs at 200MHzArticle contains a block diagram.Bill GiovinoExecutive Editorhttp://Microcontroller.com
http://microcontroller.com/news/ti_msp430_50newdevices.aspOver 50 new devices, including cool new features such as 20-bit addressingand run...
http://microcontroller.com/news/ti_msp430_50newdevices.aspOver 50 new devices, including cool new features such as 20-bit addressingand run current of only 200 ?A/MIPS.- Bill Giovino Executive Editor http://Microcontroller.com
Hello all,We are having a hard time finding a suitable microcontroller for our new automotive project. The product will have to operate in a...
Hello all,We are having a hard time finding a suitable microcontroller for our new automotive project. The product will have to operate in a very harsh enviroment including temperatures lower than -40 deg. C.Most microcontroller has -40 deg. C. as the lowest limit. Anyone here knows of microcontrollers that maybe goes to -50 deg. C. ?All architectures are welcome!Best Regards...
Freescale as introduced the S12XE 16-bit microcontroller product line. First device has1MByte of...
Freescale as introduced the S12XE 16-bit microcontroller product line. First device has1MByte of Flash:http://www.microcontroller.com/news/Freescale_S12XE.aspLot and lots of peripherals!Regards,- Bill Giovino Executive Editor http://Microcontroller.com
I wrote up some of my thoughts about various microcontroller families.My intent is to mostly to help newbies and students decide what typeof...
I wrote up some of my thoughts about various microcontroller families.My intent is to mostly to help newbies and students decide what typeof microcontrollers to start with.http://www.ericengler.com/downloads/microcontroller%20family%20selection%20guide.pdfFeel free to correct any possible errors, but I have a right to keepmy opinions unless you can change them by presenting new infor...
Microchip, in cooperation with NASA, has launched SuitSat-1, based on the PIC18microcontroller.Actually, it's a pretty cool embedded systems...
Microchip, in cooperation with NASA, has launched SuitSat-1, based on the PIC18microcontroller.Actually, it's a pretty cool embedded systems project...http://Microcontroller.com/news/microchip_SuitSat1_NASA.aspRegards,Bill GiovinoExecutive Editorhttp://Microcontroller.com
Hello all,Consider the atmega48 microcontroller by Atmel corp. I want to connectsits USART to my PC. Basically i want the microcontroller to...
Hello all,Consider the atmega48 microcontroller by Atmel corp. I want to connectsits USART to my PC. Basically i want the microcontroller to talk to tocomputer.How can i do this?1. Using a serial port?2. Can a build my own PCI/ISA card for the pc so that it can read fromthe uC and send the data to the computer where other devices can usethe information?3. Other options?...
Hi All, I would like to hear your input for the selection of amicrocontroller used on a vehicle gudiance/navigation system. Thevehicle is...
Hi All, I would like to hear your input for the selection of amicrocontroller used on a vehicle gudiance/navigation system. Thevehicle is required to track a long range signal beacon (~30metersaway). The requirement of the microcontroller is: 1) low cost 2)programmable in C and 3) easy to debug. I would appreciate any suggestions that you can bring. Regards,PQ
Hi,I am a student of computer science. I am new in embedded world. I havesome MAC7121 microcontroller. Can write the flash memory of...
Hi,I am a student of computer science. I am new in embedded world. I havesome MAC7121 microcontroller. Can write the flash memory of thatmicrocontroller through parallel port of pc(Using some externalcircuit). If I can then please explain the way & give necessary links.Also give info about external circuit if it is necessary. If I can't isany 32 bit microcontroller exists in whose fla...
Please can i have your help?I'm confused about the following situation:A transceiver is connected in SPI mode to a...
Please can i have your help?I'm confused about the following situation:A transceiver is connected in SPI mode to a microcontroller(LPC12xx).The transceiver outputs a continous clock ,and it does not drive any SSEL line to enable the SPI section of the microcontroller.The microcontroller should decide when to start a data transmission,but just enabling its SPI module it goes in Busy...
Hi, I am considering using an ENC28J60 to provide ethernet access for myproject; however, I am required to build a separate board for...
Hi, I am considering using an ENC28J60 to provide ethernet access for myproject; however, I am required to build a separate board for mymicrocontroller. Can you guys suggest a microcontroller which is easiest(in terms of interfacing and coding) to use to drive the enc28j60? Ilooked at PIC because they offer royalty-free tcp/ip stack code but I'mnot familiar with them I don't even know if a se...
I want a microcontroller (Atmega48) to send a network packet to acomputer NIC. What do i need to do to achieve this. The microcontrollerwill...
I want a microcontroller (Atmega48) to send a network packet to acomputer NIC. What do i need to do to achieve this. The microcontrollerwill send a simple 144 byte packet and thats it. I just want to knowhow the computer can receive this properly. Do i do it through themicrocontrollers UART? Or?
Hi all,I seem to be stuck with what seemed a very simple task. I want to convert a Simulink model with one input and one output to a C...
Hi all,I seem to be stuck with what seemed a very simple task. I want to convert a Simulink model with one input and one output to a C program that I could run on a microcontroller (any microcontroller, not only those TI chips on those development boards). It should be able to read some data from a ADC, do some processing (as defined by the model -- amplify/multiply by 2 is a fine st...
http://www.microcontroller.com/news/arm_cortex_stm.aspSTMicroelectronics has introduced the new STM32 microcontroller family, based on...
http://www.microcontroller.com/news/arm_cortex_stm.aspSTMicroelectronics has introduced the new STM32 microcontroller family, based on theHarvard architecture ARM Cortex.Article includes a roadmap and a useful chart of the STM32 low power operation, which isas low as 0.5mA/MHz.RegardsBill GiovinoExecutive Editorhttp://Microcontroller.com
