Load-bearing wall

The load-bearing wall of masonry is thickened in proportion to the forces it has to resist: its own load, the load of floors, roofs, persons, etc., and thelateral forces of arches, vaults, wind, etc., that may cause it to crack or buckle. Its thickness often can be reduced at the top, because loads accumulate toward the base; in high buildings this is done by interior or exterior setbacks at the floor level of upper stories. Walls that must resist lateral forces are thickened either along the whole length or at particular points where the force is concentrated. The latter method is calledbuttressing. Doors and windows weaken the resistance of the wall and divert the forces above them to the parts on either side, which must be thickened in proportion to the width of the opening. In multistory buildings, windows—unless they are very small—must be placed one above the other so as to leave uninterrupted vertical masses of wall between them to transfer loads directly to the ground. The number of openings that can be used depends on the strength of the masonry and the stresses in the wall. Walls in light, wood-framed structures and in reinforced-concreteconstruction may have abearing function also. But the nature of the material admits other means of resisting forces than the increase of mass.

The placement of walls is determined by the type of support for floors and roofs. The commonest support is the beam, which must be jointed to walls at both ends; consequently, its maximum permissible length establishes the distance between bearing walls. All floors and coverings are most easily supported on straight, parallel walls except the dome (see belowDome).

Nonbearing wall

Excluding the independent garden variety, the nonbearing wall appears only where loads are carried by other members, as in heavy timber and other skeletal structures. Modern steel and reinforced-concrete frames require exterior walls only for shelter and sometimesdispense with them on the ground floor to permit easier access. Since the wall rests or hangs upon members of the frame, it becomes a curtain or screen and admits treatment in any durable, weather-resisting material. Traditional materials are often used, but light walls of glass, plastic, metal alloys, wood products, etc., can be equally efficient. This freedom of choice extends also to the form of walls and offers greatly expanded opportunities for creative expression.