I want to have a Raspberry Pi play and record the audio from tapes. To do this, (according to my understanding) I'd need to have the play heads (which 'read' the tape) interface with the Pi somehow, ...

My goal is to stream both the raw camera feed as well as a processed video feed with object detection overlay from the IMX500 simultaneously. I've been able to get both of these operational ...

Is there a way to add a "shortcut" - either via an icon on the taskbar, or the desktop - to toggle the mouse between left handed and right handed on the latest Raspberry Pi OS (trixie)?I ...

I have a Raspberry pi 5 I had not used in years. So today I got around to reflashing the SD card using the official raspberry pi imager. I used a 128GB sandiask. The imaging went fine.Then during ...

I want to connect devices from China that are usually esp32-based devices, and are always serial in nature. So I technically don't need to allow HID devices or ethernet devices or anything, on some ...

I have an RPi zero W that's running a recent image of DietPi.I want to add motion detection and video recording to my project and, as you may already know, Motioneye doesn't perform well on the zero....

Background: I'm 100% new to raspberry pi. I have a passing acquaintance with *nix in general, but am by no means an expert.All the articles I have read make it seem like Kodi supports Netflix, and ...

Getting this on sudo apt-get update:Err:5 http://raspbian.raspberrypi.org/raspbian buster Release 404 Not Found [IP: 93.93.128.193 80]http://93.93.128.193/raspbian/dists/buster/...

I have just bought a Pi-5 from GeekPi kit (that includes the box). Both my previous projects using Pi-3 failed in the same fashion - the SD card died. Both cards were well known brands such as ...

I have an RPi 4 up andrunning and I want to be able to access it over the internet using TigerVNC.I can access the Pi from a laptop that is on my local wifi network, but I cannot access it from ...

I found this app, Serial Bluetooth Terminal, on Play Store and I'd like to use it to communicate with my Raspberry Pi 3B+.I understand that I need some kind of “Bluetooth server” running on my Pi and ...

GOALI would like to confirm that my PL2303 Cable will not damage the rPi. As I understand it, the Tx line must be 3.3V and not 5V.VOLTAGE TESTThis test was indicated by DeepSeek:Plug into Mac (...

The LTE module (EC25AFAR05A07M4G) is connected to a Raspberry Pi 4 through USB 2.0, but it is not being detected in the Raspberry Pi 4.The same LTE module setup works correctly when connected to a ...

I'm trying to make an RC plane with a Raspberry Pi 4, and I am pretty new to electronics.I have some DC motors for the propulsion and, for the control surfaces, a small servo and a 28BYJ 5V stepper ...

I'm trying to light up a LED on GPIO pin 17 when an IR signal is received on GPIO pin 23. LIRC is also configured to listen to IR signals on this PIN through dtoverlay=gpio-ir,gpio_pin=23 in /boot/...