This is inspired by the linker sripts on the AVR architecture, which
support a .noinit section (or any section starting with .noinit,
actually) for variables that should be allocated an address in RAM, but
not be initialized to any particular value (not even zero) on startup.
These can then be used to remember values across resets.

From the sketch perspective, this works exactly the same as on AVR: Just
annote a global variable with__attribute__((__section__(".noinit")))
and it will have an unpredictable value on power-up and retain its value
during resets.

To implement this without having to change all board-specific linker
scripts, the linker commandline is changed to pass the board-specific
linker script to the--default-script linker script, and change the
main linker script (passed to--script, previously-T) to a generic
"override" linker script. This new generic linker script contains an
INSERT BEFORE command, which causes the linker to load itin addition
to the default linker script, while adding an extra.noinit output
section in the right place.

Because these new variables take up RAM but have their own section in
the .elf file, they should be accounted for in the size summary after
compilation. This is done by adapting therecipe.size.regex.data entry
to include this new section.

I originally implemented this for the reset-to-bootloader in#710, but I think this is useful by itself as well, for sketches to use, even when#710 might not end up using this. Also, since this is distinct feature, it helps unclutter#710 by merging this separately.

To test it, consider the following sketch:

unsigned boot_count __attribute__((__section__(".noinit")));void setup() {    Serial.begin(115200);    while (!Serial); // Wait for serial port open    // Initialize the variable only on first power-on reset    if (__HAL_RCC_GET_FLAG(RCC_FLAG_PORRST))        boot_count = 1;    __HAL_RCC_CLEAR_RESET_FLAGS();        Serial.print("Boot number: ");    Serial.println(boot_count);    ++boot_count;}void loop() { }

This shows the number of boots since the last POR by incrementing a noinit variable across resets. Note that when you first upload this, it might not start at 1 but at some arbitrary value, because typically the first boot after an upload is not a power-on-reset. To start at 1, disconnect and reconnect power.