Repository files navigation

Hardware:

• PC with SDIO host (For example Raspberry Pi, Beaglebone, etc)

Software:

• Linux
• Python3

Install python3-venv package.In this folder execute following commands:

python3 -m venv venv./venv/bin/pip install -r requirements.txt

That's it.

In general code should be self-explanatory. But there is a small built-in help, just run

./MstarUtil.py -h

./MstarUtil.py validate ../MstarUpgrade.bin

It will parse update header and dump partitions and actions.

Important notice: your must have sdio host controller to access emmc boot partitions and service data. Application will fail if it's not present.

./MstarUtil.py write ../MstarUpgrade.bin /dev/mmcblk2

It is going to turn off pi's internal wifi, but totally worth it.

Pinout:https://pinout.xyz/pinout/sdio

Load device tree overlay for 4-bit wide bus:

dtoverlay sdio

Also we can access EMMC card with only 1 data line.Load device tree overlay for 1-bit wide bus:

dtoverlay sdio bus_width=1

After that command you'll see new devices:

/dev/mmcblk2        # main storage/dev/mmcblk2boot0   # main boot partition/dev/mmcblk2boot1   # second boot partition, normally not used/dev/mmcblk2rpmb    # rpmb special device

mmc-utils can provide detailed information for connected flash.

Keep in mind that wires must have same length.