Commitdb308ef

committed

refactor: apply review comments

1 parentcfdc66f commitdb308efCopy full SHA for db308ef

File tree

-2

lines changed

-2

lines changed

Lines changed: 2 additions & 2 deletions

Original file line number	Diff line number	Diff line change
`@@ -185,6 +185,6 @@ where`
`185`	`185`	/// Set ALPN for `TlsConnectorBuilder`
`186`	`186`	`///`
`187`	`187`	/// This is required when using `sslnegotiation=direct`
`188`		`-pubfnset_postgresql_alpn(builder:&mutTlsConnectorBuilder)->&mutTlsConnectorBuilder{`
`189`		`- builder.request_alpns(&["postgresql"])`
	`188`	`+pubfnset_postgresql_alpn(builder:&mutTlsConnectorBuilder){`
	`189`	`+ builder.request_alpns(&["postgresql"]);`
`190`	`190`	`}`

Lines changed: 1 addition & 0 deletions

Original file line number	Diff line number	Diff line change
`@@ -41,6 +41,7 @@ use tokio_postgres::{Error, Socket};`
`41`	`41`	`/// can be specified, separated by commas. Each host will be tried in turn when connecting. Required if connecting`
`42`	`42`	/// with the `connect` method.
`43`	`43`	/// * `sslnegotiation` - TLS negotiation method. If set to `direct`, the client will perform direct TLS handshake, this only works for PostgreSQL 17 and newer.
	`44`	+/// Note that you will need to setup ALPN of TLS client configuration to `postgresql` when using direct TLS.
`44`	`45`	/// If set to `postgres`, the default value, it follows original postgres wire protocol to perform the negotiation.
`45`	`46`	/// * `hostaddr` - Numeric IP address of host to connect to. This should be in the standard IPv4 address format,
`46`	`47`	`/// e.g., 172.28.40.9. If your machine supports IPv6, you can also use those addresses.`

Lines changed: 1 addition & 0 deletions

Original file line number	Diff line number	Diff line change
`@@ -117,6 +117,7 @@ pub enum Host {`
`117`	`117`	`/// can be specified, separated by commas. Each host will be tried in turn when connecting. Required if connecting`
`118`	`118`	/// with the `connect` method.
`119`	`119`	/// * `sslnegotiation` - TLS negotiation method. If set to `direct`, the client will perform direct TLS handshake, this only works for PostgreSQL 17 and newer.
	`120`	+/// Note that you will need to setup ALPN of TLS client configuration to `postgresql` when using direct TLS.
`120`	`121`	/// If set to `postgres`, the default value, it follows original postgres wire protocol to perform the negotiation.
`121`	`122`	/// * `hostaddr` - Numeric IP address of host to connect to. This should be in the standard IPv4 address format,
`122`	`123`	`/// e.g., 172.28.40.9. If your machine supports IPv6, you can also use those addresses.`

Comments

(0)