Repository files navigation

Just do the following one by one, and you should be fine.

You will need Java to work with this Clojure workshop content.

First, make sure you have Java 8.

• Runjava -version in your terminal.
• If Java is not installed, pleasedownload and install Java 8 from here.
• Once you are done,java -version should show you a Java 1.8.x version.

Notes:

• If you have Java 9+, that should be OK too.
• The LightTable editor is known to break with Java 9. Use Java 8 if you are keen on using LightTable.
• We have not tested this project with Java 7 and earlier.

FollowLeiningen setup instructions here.

• Clone this project
• Open your terminal, and do the following.
• cd into this project's root directory
• Uselein repl command to start a REPL with Leiningen.
• Wait for it... the REPL will start and print out a message with someuseful information
• Locate theport andhost information in the message. We will need this information soon.

Note:

• Boot should be fine too, but you may need to generate your ownboot file(s).

Set up an editor and figure out how to evaluate Clojure code with it.We are fine with you choosing the editor as long as your editor can do,

• Connect to a Clojure REPL from the editor
  • Evaluate snippets and/or entire namespaces in the connected REPL from the editor.
• Code navigation
• Paredit / Parinfer

Editors we can help out with

• Emacs
• Vim
• Cursive

If you don't have an editor setup, we suggest you use Cursive with IntelliJ. Please follow instructions fromhere.Do note that you may need to use it in trial mode or get an appropriate license ahead of time. There's a cost-free license available for personal/non-commercial hacking.

Copyright � 2018-2019IN/Clojure.

Distributed under theMIT license.