Repository files navigation

Create and demonstrate iBeacon using JDY-08 module with HM-10 firmware.The UUID string, major, and minor numbers are dynamically and periodically changeable during operation.

The story behind this is that I want to make an iBeacon without any high-cost Arduino shield or dedicated Arduino IDE compatible BLE (Bluetooth Low Energy) platform such as nordicRF RedBear BLEs. When I found some really inexpensive BLE module on some online shops (JDY-08 BLE module), I quickly checked the datasheet and bought some. Later, I learned that these modules can be re-flashed using HM-10 BLE firmware and then be transformed into an iBeacon. I already wrote another repo which describes the process to re-flash JDY-08 module with HM-10 firmware, here in myGitHub page orGitHub repo.

• JDY-08 BLE module with HM-10 firmware installed please checkout in myGitHub page orGitHub repo.
• Arduino UNO or any pin compatible board.
• Android BLE Scanner and / or iBeacon Locator app on your smartphone.
• One 1k resistor and One 2k2 resistor. Values are not extremely critical.
• Breadboard and some jumper wires

I included the fritzing wiring file iniBeacon/Fritzing folder (optional) if you wanna check it out.

• UUID string : 74278BDA-B644-4520-8F0C-720EAF059935
• MAJOR : 0xFFE0
• MINOR : 0XFFE1

The Arduino Sketch for this demo included iniBeacon/Aduino-Sketches/Static_iBeacon

Then i tried to use the iBeacon locator app to find the furthest distance i can detect it.

As it turns out, it was about 10 meters (indoor).

The Arduino Sketch for this demo included iniBeacon/Aduino-Sketches/Dinamic_iBeacon.Here you see the serial monitor output when it was a one-time-only configuration (left) and periodic configuration (right)

While it was running, you can comfirm the parameter changes with the BLE scanner or iBeacon locator app

Thank you for:

• https://www.iot-experiments.com/jdy-08/
• https://elementztechblog.wordpress.com/2017/03/23/ibeacon-using-hm10-ble-module/
• https://github.com/RedBearLab/CCLoader
• https://github.com/PaulStoffregen/AltSoftSerial

1. Fork ithttps://github.com/handiko/iBeacon/fork
2. Create new branch (git checkout -b myfeature)
3. Do some editing / create new feature
4. Commit your works (git commit -m "Adding some myfeature blah blah..")
5. Push to the branch (git push -u origin myfeature)
6. Create a new Pull Request...