Asplit-ring resonator (SRR) is an artificially produced structure common tometamaterials. Its purpose is to produce the desiredmagnetic susceptibility (magnetic response) in various types ofmetamaterials up to 200terahertz.

Split ring resonators (SRRs) consist of a pair ofconcentric metallic rings, etched on adielectric substrate, with slits etched on opposite sides. SRRs can produce the effect of being electrically smaller when responding to anoscillatingelectromagnetic field. These resonators have been used for the synthesis of left-handed and negative refractive index media, where the necessary value of the negative effective permeability is due to the presence of the SRRs. When an array of electrically small SRRs is excited by means of a time-varyingmagnetic field, the structure behaves as aneffective medium with negative effective permeability in a narrow band above SRRresonance. SRRs have also been coupled to planartransmission lines for the synthesis ofmetamaterials transmission line.^[4][5][6][7]These media create the necessary strong magnetic coupling to an appliedelectromagnetic field not otherwise available in conventional materials. For example, an effect such as negativepermeability is produced with a periodic array of split ring resonators.^[8]

A single-cell SRR has a pair of enclosed loops with splits in them at opposite ends. The loops are made ofnonmagnetic metal likecopper and have a small gap between them. The loops can beconcentric or square, and gapped as needed. Amagnetic flux penetrating the metal rings willinduce rotating currents in the rings, which produce their own flux to enhance or oppose theincident field (depending on the SRR resonant properties). Thisfield pattern isdipolar. The small gaps between the rings produces largecapacitance values, which lowers the resonatingfrequency. Hence the dimensions of the structure are small compared to theresonant wavelength. This results in lowradiative losses and very highquality factors.^[8][9][10]

The split ring resonator was a microstructure design featured in the paper by Pendry et al in 1999 called, "Magnetism from Conductors and Enhanced Nonlinear Phenomena".^[11] It proposed that the split ring resonator design, built out of nonmagnetic material, could enhance the magnetic activity unseen in natural materials. In the simple microstructure design, it is shown that in an array of conductingcylinders, with an applied external${\displaystyle H_0}$ field parallel to the cylinders, the effective permeability can be written as the following. (This model is very limited and the effective permeability cannot be less than zero or greater than one.)^[5]

${\displaystyle {\mu }_{eff}=1-\frac{\pi r^2}{a^2}{\left(1+i\frac{2\sigma }{\omega r{\mu }_0}\right)}^{-1}}$

Where${\displaystyle \sigma }$ is the resistance of the cylinder surface per unit area, a is the spacing of the cylinders,${\displaystyle \omega }$ is the angular frequency,${\displaystyle {\mu }_0}$ is the permeability of free space and r is the radius. Moreover, when gaps are introduced to a double cylinder design similar to the image above, we see that the gaps produce a capacitance. This capacitor and inductor microstructure design introduces a resonance that amplifies the magnetic effect. The new form of the effective permeability resembles a familiar response^[12] known in plasmonic materials.

${\displaystyle {\mu }_{eff}=1-\frac{\frac{\pi r^2}{a^2}}{1+\frac{2\sigma i}{\omega r{\mu }_0}-\frac{3d{c}_0^2}{{\pi }^2{\omega }^2{r}^3}}}$

Where d is the spacing of the concentric conducting sheets^{[clarification needed]}. The final design replaces the double concentric cylinders with a pair of flat concentric c-shaped sheets, placed on each side of a unit cell. The unit cells are stacked on top of each other by a length, l. The final result of the effective permeability can be seen below.

${\displaystyle {\mu }_{eff}=1-\frac{\frac{\pi r^2}{a^2}}{1+\frac{2l{\sigma }_{1}i}{\omega r{\mu }_0}-\frac{3l{c}_0^2}{\pi {\omega }^2{r}^{3}ln(\frac{2c}{d})}}}$

where c is the thickness of the c-shaped sheet and${\displaystyle \sigma }$ is the resistance of unit length of the sheets measured around the circumference.^[5]

The split ring resonator and themetamaterial itself are composite materials. Each SRR has an individual tailored response to the electromagnetic field. However, the periodic construction of many SRR cells is such that the electromagnetic wave interacts as if these werehomogeneous materials. This is similar to how light actually interacts with everyday materials; materials such as glass or lenses are made of atoms, an averaging or macroscopic effect is produced.

The SRR is designed to mimic the magnetic response of atoms^{[clarification needed]}, only on a much larger scale. Also, as part of periodic composite structure, the SRR is designed to have a stronger magnetic coupling than is found in nature. The larger scale allows for more control over the magnetic response, while each unit is smaller than the radiatedelectromagnetic wave.

SRRs are much more active^{[clarification needed]} thanferromagnetic materials found in nature. The pronounced magnetic response in such lightweight materials^{[clarification needed]} demonstrates an advantage over heavier, naturally occurring materials. Each unit can be designed to have its own magnetic response. The response can be enhanced or lessened as desired. In addition, the overall effect reduces power requirements.^[8][13]

There are a variety of split-ring resonators andperiodic structures: rod-split-rings, nested split-rings, single split rings, deformed split-rings, spiral split-rings, and extended S-structures. The variations of split ring resonators have achieved different results, including smaller and higher frequency structures. The research which involves some of these types are discussed throughout the article.^[14]

To date (December 2009) the capability for desired results in thevisible spectrum has not been achieved. However, in 2005 it was noted that, physically, a nested circular split-ring resonator must have an inner radius of 30 to 40nanometers for success in the mid-range of the visible spectrum.^[14]Microfabrication andnanofabrication techniques may utilizedirect laser beam writing orelectron beam lithography depending on the desired resolution.^[14]

This section'stone or style may not reflect theencyclopedic tone used on Wikipedia. See Wikipedia'sguide to writing better articles for suggestions.(October 2017) (Learn how and when to remove this message)

Split-ring resonators (SRR) are one of the most common elements used to fabricatemetamaterials.^[16] Split-ring resonators arenon-magnetic materials, which initially were fabricated fromcircuit board material to create metamaterials.^[17]

Looking at the image directly to the right, it can be seen that at first a single SRR looks like an object with two square perimeters, with each perimeter having a small section removed. This results in square "C" shapes on fiberglassprinted circuit board material.^[16][17] In this type of configuration it is actually twoconcentric bands ofnon-magnetic conductor material.^[16] There is one gap in each band placed 180° relative to each other.^[16] The gap in each band gives it the distinctive "C" shape, rather than a totally circular or square shape.^[18][16][17] Then multiple cells of this double band configuration are fabricated onto circuit board material by an etching technique and lined with copper wire strip arrays.^[17] After processing, the boards are cut and assembled into an interlocking unit.^[17] It is constructed into aperiodic array with a large number of SRRs.^[17]

There are now a number of different configurations that use the SRR nomenclature.

Aperiodic array of SRRs was used for the first demonstration of a negativeindex of refraction.^[17] For this demonstration,square shaped SRRs, with the lined wire configurations, were fabricated into a periodic, arrayed, cell structure.^[17] This is the substance of the metamaterial.^[17] Then a metamaterialprism was cut from this material.^[17] The prism experiment demonstrated a negative index of refraction for the first time in the year 2000; the paper about the demonstration was submitted to the journalScience on January 8, 2001, accepted on February 22, 2001 and published on April 6, 2001.^[17]

Just before this prism experiment,Pendry et al. was able to demonstrate that a three-dimensional array of intersecting thin wires could be used to create negative values of ε. In a later demonstration, a periodic array of copper split-ring resonators could produce an effective negative μ. In 2000 Smith et al. were the first to successfully combine the two arrays and produce a so-calledleft-handed material, which has negative values of ε and μ for a band of frequencies in the GHz range.^[17]

SRRs were first used to fabricate left-handed metamaterials for themicrowave range,^[17] and several years later for theterahertz range.^[19] By 2007, experimental demonstration of this structure at microwave frequencies has been achieved by many groups.^[20] In addition, SRRs have been used for research in acoustic metamaterials.^[21] The arrayed SRRs and wires of the first left-handed metamaterial were melded into alternating layers.^[22] This concept and methodology was then applied to (dielectric) materials withoptical resonances producing negative effective permittivity for certain frequency intervals resulting in "photonic bandgap frequencies".^[21] Another analysis showed left-handed materials to be fabricated from inhomogeneous constituents, which yet results in a macroscopicallyhomogeneous material.^[21] SRRs had been used to focus a signal from a point source, increasing the transmission distance fornear fieldwaves.^[21] Furthermore, another analysis showed SRRs with a negative index of refraction capable of high-frequencymagnetic response, which created an artificial magnetic device composed of non-magnetic materials (dielectric circuit board).^[17][21][22]

The resonance phenomena that occurs in this system is essential to achieving the desired effects.^[20]

SRRs also exhibit resonant electric response in addition to their resonant magnetic response.^[22] The response, when combined with an array of identical wires, is averaged over the whole composite structure which results in effective values, including the refractive index.^[23] The original logic behind SRRs specifically, and metamaterials generally was to create a structure, which imitates an arrayed atomic structure only on a much larger scale.

In research based in metamaterials, and specificallynegative refractive index, there are different types of split-ring resonators. Of the examples mentioned below, most of them have a gap in each ring. In other words, with a double ring structure, each ring has a gap.^[24]

There is the1-D Split-Ring Structure with twosquare rings, one inside the other. One set of cited "unit cell"dimensions would be an outersquare of 2.62 mm and an inner square of 0.25 mm. 1-D structures such as this are easier to fabricate compared with constructing a rigid 2-D structure.^[24]

TheSymmetrical-Ring Structure is another classic example. Described by the nomenclature these are tworectangular square D type configurations, exactly the same size, lying flat, side by side, in theunit cell. Also these are notconcentric. One set of cited dimensions are 2 mm on the shorter side, and 3.12 mm on the longer side. The gaps in each ring face each other, in the unit cell.^[24]

TheOmega Structure, as the nomenclature describes, has an Ω-shaped ring structure.^[25] There are two of these, standing vertical, side by side, instead of lying flat, in the unit cell. In 2005 these were considered to be a new type of metamaterial. One set of cited dimensions are annular parameters of R=1.4 mm and r=1 mm, and the straight edge is 3.33 mm.^[24]

Another newmetamaterial in 2005 was a coupled S-shaped structure. There are two vertical S-shaped structures, side by side, in a unit cell. There is no gap as in the ring structure; however, there is a space between the top and middle parts of the S and space between the middle part and bottom part of the S. Furthermore, it still has the properties of having an electric plasma frequency and a magnetic resonant frequency.^[24][26]

On May 1, 2000, research was published about an experiment which involved conducting wires placed symmetrically within each cell of aperiodic split-ring resonatorarray. This effectively achieved negative permeability and permittivity forelectromagnetic waves in themicrowave regime. The concept was and still is used to build interacting elements smaller than the applied electromagnetic radiation. In addition, the spacing between the resonators is much smaller than the wavelength of the applied radiation.^[27]

Additionally, the splits in the ring allow the SRR unit to achieve resonance at wavelengths much larger than the diameter of the ring. The unit is designed to generate a large capacitance, lower the resonant frequency, and concentrate the electric field. Combining units creates a design as a periodic medium. Furthermore, the multiple unit structure has strong magnetic coupling with low radiative losses.^[27]Research has also covered variations in magnetic resonances for different SRR configurations.^[28][29][30]Research has continued into terahertz radiations with SRRs^[31] Other related work fashioned metamaterial configurations with fractals^[25] and non-SRR structures. These can be constructed with materials such as periodic metallic crosses, or an ever-widening concentric ring structures known as Swiss rolls.^{[32][33][34][35]} Permeability for only the red wavelength at 780 nm has been analyzed and along with other related work.^[36][37][38]

• Ates, Damla; Cakmak, Atilla Ozgur; Colak, Evrim; Zhao, Rongkuo; Soukoulis, C. M.; Ozbay, Ekmel (2010)."Transmission enhancement through deep subwavelength apertures using connected split ring resonators"(Free PDF download).Optics Express.18 (4):3952–66.Bibcode:2010OExpr..18.3952A.doi:10.1364/OE.18.003952.hdl:11693/13284.PMID 20389408.
• Shepard, K. W. et al.Split-ring resonator for the Argonne Superconducting Heavy Ion Booster. IEEE Transactions on Nuclear Science, VoL. NS-24, N0.3, JUN 1977.

Look upmetamaterials in Wiktionary, the free dictionary.

Look upsplit-ring resonator in Wiktionary, the free dictionary.

Wikimedia Commons has media related toMetamaterials.

Wikimedia Commons has media related tometamaterials.

• Video: John Pendry lecture: The science of invisibility April 2009, SlowTV
• Split Ring Resonator Calculator: Online tool to calculate the LC equivalent circuit and resonant frequency of SRR and CSRR topologies.

• Resonators
• Materials science
• Electromagnetic radiation
• Metamaterials
• Scattering, absorption and radiative transfer (optics)
• Optical materials

• CS1 errors: external links
• CS1 errors: periodical ignored
• CS1: long volume value
• Webarchive template wayback links
• Articles with short description
• Short description matches Wikidata
• All accuracy disputes
• Articles with disputed statements from November 2021
• Wikipedia articles needing clarification from November 2021
• Wikipedia articles with style issues from October 2017
• All articles with style issues
• Commons category link from Wikidata
• Commons category link is locally defined