USSFlusser
Class overview
Name	Smith class
Builders	Bath Iron Works, ME (2) William Cramp & Sons, PA (1) New York Shipbuilding, NJ (1)
Operators	United States Navy
Preceded by	Truxtun class
Succeeded by	Paulding class
Subclasses	Flusser
Built	1908–1910
In commission	1909–1919
Completed	5
Scrapped	5
General characteristics
Type	Destroyer
Displacement	700 long tons (710 t) (normal) 902 long tons (916 t) (full load)
Length	293 ft 10 in (89.56 m)
Beam	26 ft 0 in (7.92 m)
Draft	8 ft 0 in (2.44 m)
Installed power	4 × Mosher coal-firedboilers 3 ×Parsonsdirect-drivesteam turbines 10,000 shp (7,500 kW) (design)
Propulsion	3 × shafts
Speed	28knots (52 km/h; 32 mph) (design)
Range	2,800 nautical miles (5,200 km) at 10 knots (19 km/h; 12 mph)
Capacity	304 long tons (309 t) coal (fuel)
Complement	4 officers 83 enlisted men
Armament	5 ×3 in (76 mm)/50 caliber guns 3 ×18 inch (450 mm)torpedo tubes, sixtorpedoes

TheSmith-class destroyers were the first ocean-going torpedo-boatdestroyers in theUnited States Navy, and the first to be driven bysteam turbines instead of thereciprocating engines fitted in the sixteen earlier and much smaller torpedo-boat destroyers ordered under the Act of 4 May 1898.Flusser andReid are sometimes considered to beFlusser-class ships. Also, sinceFlusser was completed first, some period documentation refers to the entire class asFlussers.^[1]

The first three of the class were ordered under the Act of 29 June 1906 "to have the highest practical speed, and to cost, exclusive of armament, not to exceed seven hundred and fifty thousand dollars each". The remaining pair were ordered under the Act of 7 March 1907 "to have the highest practical speed, and to cost, exclusive of armament, not to exceed eight hundred thousand dollars each".^[1]

All of the ships served asconvoy escorts inWorld War I, and several attackedU-boats. The latter four vessels were all sold in November 1919 following the end of World War I;Smith survived another two years as a bombing target until scrapped.^[2]

These were the firstturbine-powered destroyers in US service, and the last to be coal-fired. Surprisingly, turbines were dictated by cost; when bids were opened, all of the turbine-powered proposals were lower than all of thereciprocating proposals.^[1] TheSmiths were greatly enlargedTruxtuns; at 900 tons full load they were 50% larger. The extra displacement went into increased armament and more powerful machinery to maintain theTruxtuns' 28-knot (52 km/h; 32 mph) speed. The raisedforecastle improved seaworthiness. Also, the coal capacity was increased to 304 tons, nearly half the total full load displacement of the previous class. The increased size and range meant that these were the US Navy's first truly ocean-going destroyers, capable of operating withbattleships on long voyages. The seizure of thePhilippines in theSpanish–American War and the acquisition ofHawaii, both in 1898, had shown the need for long-range ships. Shortly before theSmith class entered service, theGreat White Fleet of 1907–09 demonstrated that the US Navy was prepared to operate far from home. Ironically, these destroyers would quickly be nicknamed "flivvers" (after the small and shakyModel T Ford) for their small size when the subsequent "thousand tonners" (Cassin throughSampson classes) entered service in 1913.^[3]

It was recognized that destroyers would now be fighting other destroyers rather thantorpedo boats, and that destroyers also needed more offensive (aka torpedo) capability to take over the torpedo boats' role, while retaining the range and seakeeping qualities to operate with the battle fleet.^[1] This was the beginning of the multiple missions that US destroyers would eventually be expected to perform, includinganti-submarine warfare beginning in World War I andanti-air warfare beginning in the 1930s.

Compared with theTruxtuns, the gun armament was increased to five3-inch (76 mm)/50 caliber guns;^[4] smaller guns were deleted to maximize the number of larger guns. This followed a trend set by the rearmament of the BritishRiver-class destroyers in 1906, which reflected the "all big gun" design of the battleshipHMS Dreadnought. A third 18-inch (457 mm)torpedo tube was added, and one torpedo reload per tube was provided. In 1911 it was noted that torpedoes fired from the stern mount at a ship's speed much above 20 knots ran erratically due to the stern wave deflecting them.^[1]

In 1916, all had their single torpedo tubes replaced by twin mounts (with no reloads) while one 3-inch gun was removed.^[2] This was an easy upgrade, as the new design twin mounts actually weighed less than the older single mounts.^[1] They were equipped with one or twodepth charge racks forconvoy escort during World War I.^[5]

Unlike the earlier 16 destroyers, these turbine-driven vessels were triple-screw. The ships'steam turbines weredirect drive and arranged in a similar manner toSir Charles Parsons'Turbinia, with a high-pressure turbine on the center shaft exhausting to two low-pressure turbines on the outboard shafts.^[6] Cruising turbines were also fitted on the outboard shafts to improve fuel economy at low speeds, a problem that would plague turbine-powered ships until fullygeared turbines and higher steam pressures and temperatures were introduced during World War I.^[7] To attempt to find a middle ground between the turbines' high efficient speed and the propellers' low efficient speed, the maximum shaft speed was 724 rpm, over twice that of a modern ship.^[1]

All had two widely spaced pairs of funnels except forSmith, which had the first and fourth funnels separated from the middle pair.

Smith had four Mosher coal-firedboilers supplying steam to three steam turbines totaling 10,000 shp (7,500 kW) (design).^[1] She made 28.35 kn (32.6 mph; 52.5 km/h) on trials at 9,946 shp (7,417 kW). Normal coal capacity was 304 tons.^[1]

Wikimedia Commons has media related toSmith class destroyers.

•  This article incorporates text from thepublic domainDictionary of American Naval Fighting Ships.

• Bauer, K. Jack; Roberts, Stephen S. (1991).Register of Ships of the U.S. Navy, 1775–1990: Major Combatants.Westport, Connecticut: Greenwood Press.ISBN 0-313-26202-0.
• Friedman, Norman (2004).US Destroyers: An Illustrated Design History (Revised ed.). Annapolis: Naval Institute Press.ISBN 1-55750-442-3.
• Gardiner, Robert; Gray, Randal (1985).Conway's All the World's Fighting Ships 1906–1921. London: Conway Maritime Press.ISBN 0-85177-245-5.
• Silverstone, Paul H. (1970).U.S. Warships of World War I. London: Ian Allan.ISBN 0-71100-095-6.

• Tin Can Sailors @ Destroyers.org –Smith class destroyer
• DestroyerHistory.orgSmith class destroyer
• DestroyerHistory.org Flivver type destroyers
• NavSource Destroyer Photo Index Page
• DiGiulian, Tony Navweaps.com 3"/50 Mks 2, 3, 5, 6, and 8
• DiGiulian, Tony Navweaps.com Pre-WWII US Torpedoes
• US Navy Torpedo History, part 2Archived 15 September 2014 at theWayback Machine

• Smith-class destroyers
• Destroyer classes
• World War I destroyers of the United States

• Articles with short description
• Short description is different from Wikidata
• Use American English from January 2014
• All Wikipedia articles written in American English
• Use dmy dates from March 2022
• Commons category link is on Wikidata
• Wikipedia articles incorporating text from the Dictionary of American Naval Fighting Ships
• Webarchive template wayback links