| Royal Aircraft Factory R.E.8 | |
|---|---|
 A vintage R.E.8 performing over theDuxford Jubilee Airshow 2012 | |
| General information | |
| Type | Reconnaissance,Bomber |
| Manufacturer | Royal Aircraft Factory |
| Designer | |
| Status | Retired |
| Primary users | RFC/RAF |
| Number built | 4,077[1] |
| History | |
| Manufactured | 1916–1918 |
| Introduction date | 1916 |
| First flight | 17 June 1916 |
| Retired | 1918 |
| Variant | Siddeley-Deasy R.T.1 |
TheRoyal Aircraft Factory R.E.8 is a British two-seatbiplanereconnaissance andbomber aircraft of theFirst World War that was designed and produced at theRoyal Aircraft Factory. It was also built under contract byAustin Motors,Daimler,Standard Motors,Siddeley-Deasy and theCoventry Ordnance Works.
Intended as a replacement for the vulnerableB.E.2, the R.E.8 was widely regarded as more difficult to fly and gained a reputation in theRoyal Flying Corps for being "unsafe" that was never entirely dispelled. Although eventually it gave reasonably satisfactory service, it was never an outstanding combat aircraft. Nonetheless, it remained the standard British reconnaissance andartillery observation aircraft from mid-1917 to the end of the war, serving alongside the rather more popularArmstrong Whitworth F.K.8.
More than 4,000 R.E.8s were eventually produced; these aircraft saw service in a range of different theatres, includingItaly,Russia,Palestine andMesopotamia, as well as theWestern Front. The R.E.8 was rapidly withdrawn from service after the end of the war, by which time it was regarded as totally obsolete.
Design of the new type had begun in late 1915,[2] so that it was conceptually at least almost contemporary with theB.E.12 and theB.E.2e – like these earlier types, it was designed for inherent stability in line with the dominant pre-war belief in the necessity of stability to perform theaerial observation role.[3]
The B.E.2 had already been subject to considerable criticism, and a deliberate effort was made to address each of the earlier type's failings. In particular, the more powerful motor was intended to improve the feeble speed and climb of the B.E.2 and to allow a better payload; this permitted the type to operate as a true two-seater: the observer no longer had to be left behind when bombs or a full fuel load were carried. There was no need for his seat to be at the centre of gravity; seated behind the pilot, instead of in front as in the B.E.2, he was in the proper position to operate a machine-gun. Another consequence of the additional engine power was the possibility of fitting a forward-mounted gun for the pilot.[4][3]
.jpg)
As early as March 1916, the design appears to have mostly been settled; features included the selection of aRoyal Aircraft Factory 4a air-cooledV12 engine (capable of 140 hp) to power the type along with a sizablefin andrudder. During the early design process, a smaller tail fin was substituted for the original, a step which later caused some controversy.[3] By early April 1916 a mock-up of the R.E.8 had been completed, and construction of a pair of prototypes was underway. On 16 June 1916, the first of these prototypes was submitted for its final pre-flight inspection in advance of the type'smaiden flight.[3]
On 17 June 1916, the first R.E.8 test flight was conducted by F.W. Goodden.[5] Goodden would perform all of the early flights with the type; on 1 July 1916,Sefton Brancker was flown by Goodden in the type toHounslow,London. On 16 July 1916, the second prototype, furnished with a different design of propeller, performed its first flight.[3] During late July 1916, the second of two prototypes was dispatched to France for service trials, the results of which were largely successful, with aircrew being generally quite favourably impressed. During August 1916, the second prototype returned toFarnborough, Hampshire, where it underwent modification based upon its experiences in France.[6]
The R.E.8 possessed a conventional wire-braced fabric-covered wooden structure, along with an unequal-span wing arrangement.[3] The engine installation closely resembled that of the B.E.12, complete with the same large air scoop and similar vertically mounted exhausts protruding over the upper wing to carry the fumes clear of the crew. Apart from the disposition of the cockpits, the main visually distinguishable difference was that the engine was slightly raked back, to improve take off and landing characteristics.[7] The early production R.E.8s were more or less identical to the prototypes.[8]
.jpg)
The R.E.8 adopted a set of single bay, unequal span wings, identical to those of the earlier B.E.2e; although the span (and thus the wing area) had been increased slightly by the use of a wider upper centre section, and lower stub wings to match. On the B.E.2e, these wings functioned to maintain the stability of the B.E.2c while providing the aircraft with superior levels of manoeuvrability; although the long extensions on the upper wing gave rise to fears they would be prone to collapse if the aircraft was dived too sharply, which in turn did not help to build trust in the aircraft.[4] Several other features, such as the tailplane, were also identical to those previously used upon the B.E.2e.
.jpg)
For the purpose of making the R.E.8 less tiring to fly, the pilot's controls included a wheel to adjust the tailplane incidence in flight and a primitive form of ruddertrim (applied to the rudder bar) was provided to alleviate the constant pressure necessary to counteract the torque generated by the propeller. Basic flight controls were installed in the observer's cockpit, which folded out of the way when not in use; these were connected to theelevators,rudder andthrottle, but not to theailerons, and were intended to give observers a chance to make a forced landing if the pilot was killed or incapacitated rather than to offer true dual control.[9]
Although not so underpowered as the B.E.2, the R.E.8 was still handicapped by a less than adequate powerplant, and a model re-engined with theHispano-Suiza engine was projected as theR.E.8a from quite an early stage. The cowling designed for the liquid-cooled engine closely resembled that of the B.E.12b or theS.E.5a. Supplies of Hispano-Suiza engines, more urgently required for other types, never permitted production of the R.E.8a, although a prototype was constructed and underwent trials during December 1916.[10] Plans to mountRolls-Royce aero engines, such as theEagle orFalcon were also abortive, for similar reasons. These engines were in chronically short supply and reserved for various other types in British service, including theAirco DH.4 and theBristol Fighter.
During August 1916, production of an initial batch of 50 aircraft was commenced by the Royal Aircraft Factory itself.[6] On 25 August, a contract was placed withAustin Motors for the completion of 100 R.E.8s; on 30 August,Siddeley-Deasy was also contracted to produce a further 100 examples.[8] By September 1916, full-scale production was well under way.[11] By the end of September, a further 850 R.E.8s had been ordered from a range of manufacturers.[8] During December 1916, the first contractor-produced R.E.8s began to appear.[12]
TheVickers-Challenger interrupter gear and theScarff ring were still in short supply, being required for theSopwith 1½ Strutter and other types; accordingly, a few early R.E.8s were built with a pillar mounting for the observer's gun as an interim measure. An alternative to the pilot's synchronised Vickers had been designed, consisting of a fixed Lewis gun with deflector plates fitted to the propeller, although this was never used, a Vickers gun for the pilot being mounted on the port side of the fuselage in a similar position to that on the B.E.12, at first synchronised by the Vickers-Challenger gear and then by the improvedConstantinesco hydraulic gear.[13][8] Photographs of this armament installation make it clear that the cocking handle of the Vickers gun was in easy reach of the pilot and that a normal Aldis sight was often mounted in the pilot's windscreen, giving the lie to statements that the forward firing gun could not be sighted properly due to its position, although the lack of standisation complicated maintenance in operational squadrons.[14]
In total, 4,077 R.E.8s were constructed; a further 353 aircraft that had been on order were cancelled following theend of the war. Only a handful of production aircraft were actually completed by theRoyal Aircraft Factory; the bulk of the work was issued out to several private companies includingAustin Motors,Daimler,Standard Motors,Siddeley-Deasy and theCoventry Ordnance Works, which were responsible for the type throughout its production life.[15]
The first production aircraft reached52 SquadronRoyal Flying Corps (RFC) in France in November 1916. The inexperienced pilots of 52 Squadron found their new mounts thoroughly dangerous and several were killedspinning in off astall while attempting to land; they were grateful to return to the B.E.2e by exchanging aircraft with34 Squadron in January 1917. Experienced pilots had fewer problems with the new type and re-equipment of B.E.2 squadrons continued. Pilot's notes for the R.E.8, prepared in the field, drew attention to the fact that it had a higher landing speed than the B.E.2e (hardly surprising, since it was heavier and had almost the same wing area) and that it gave almost no warning of a stall.[13] This seems to have been the source of most complaints about the type's "trickiness".
The Royal Aircraft Factory conducted spinning tests on the type, concluding that the R.E.8 was quite hard to spin and recovered easily; but the fin was redesigned with slightly increased area to improve spin recovery. The modification resulted in the production version being no less stable than the B.E.2e; and while this was an advantage for artillery observation and photography it gave the R.E.8 little chance to out-manoeuvre enemy fighters. An even larger fin was fitted to some R.E.8s used as trainers. Some pilots flew the R.E.8 with an empty reserve fuel tank (or even filled the tank with fire extinguisher fluid) to avoid a perceived tendency of R.E.8s to burn on crashing. None of these measures would have made the aircraft any "safer", if the problem was one of poor stalling characteristics. Several pilots who flew the type mentioned that they had no problems but were careful to keep the airspeed well above stalling point.[16]
.jpg)
R.E.8s began to arrive at the front in numbers just as the period of German air superiority known as "Bloody April" was taking a heavy toll of all types in the RFC; and early service was not auspicious. On 13 April 1917, six R.E.8s from59 Squadron were sent on a long range photo reconnaissance mission, missed their intended escorts, and were met by the picked fighter pilots ofJasta 11, who shot them all down within five minutes.[17]
The casualty rate in R.E.8 squadrons became more sustainable as new Allied fighter types regained air superiority and pilot training and tactics improved. Although never a popular aeroplane, it was reasonably satisfactory for the tasks demanded of it and was even regarded with some affection, gaining therhyming slang nickname "Harry Tate" (after a popularmusic hall artist of the time). Some crews flew their slow, cumbersome mounts quite aggressively; the German fighter aceEduard Ritter von Dostler was shot down by an R.E.8 of7 Squadron, while3 SquadronAustralian Flying Corps (AFC) was credited with 50 air victories in 12 months of operations.[18] LtsPithey andRhodes of12 Squadron were the most successful R.E.8 crew in air-to-air combat, being credited with twelve victories.[19]
.jpg)
Although supplemented by other types, the R.E.8 remained the standard RFC artillery observation, air photography and general short range reconnaissance aircraft for the remainder of the war, equipping 18 RFC squadrons in 1917 and 19 squadrons in 1918.Belgium was the only country other than Britain and the Dominions to operate the R.E.8 during the First World War, receiving 22 in July 1917. At least some of the Belgian examples were fitted with Hispano-Suiza engines, in a SPAD type cowling, rather than the S.E.5a type cowling of the R.E.8a.[10]
It was hoped to be able to replace the R.E.8 with a version of theBristol Fighter powered by theSunbeam Arab engine but the combination proved unsuccessful and few "Arab Bristols" were ever built.[20] A few R.E.8 squadrons were issued with one or two standard (Falcon engined) F.2bs in the last weeks of the war.[21] By November 1918, the R.E.8 was regarded as totally obsolete and surviving examples were quickly retired after theArmistice. Nor was the type popular with the private owners who purchased surplus RAF aircraft after the war and no R.E.8s came onto the civil register.
Only two "original" R.E.8s survive from World War One.[1]
The restoration of R.E.8F3556 at theImperial War Museum Duxford was completed in 2004. This aircraft, built byDaimler, arrived in France onArmistice Day, still in its original packing case. It is currently displayed suspended from the roof of the AirSpace hangar at Duxford.[23]
The other surviving R.E.8 is a formerAviation Militaire Belge machine preserved at the Brussels Air Museum. It is fitted with the usual Hispano-Suiza engine typical of R.E.8s in Belgian service, in the usual SPAD type cowling and circular frontal radiator.[24]
The Royal Air Force Museum at Hendon has a full size replica R.E.8, which was built by The Vintage Aviator Ltd ( TVAL ) in New Zealand in 2011. It is fitted with a "new build" RAF 4a engine and was successfully test flown at Masterton, NZ, on 1 January 2012, with the registration ZK-TVC. Crated and shipped to England, it was reassembled at The Shuttleworth Collection at Old Warden Airfield in June 2012 and undertook a number of flights painted as 'A3930' of No. 9 Squadron Royal Flying Corps, before being sent by road to Hendon in November 2012. It is now on static display in the Grahame-White Factory.[25]
TheRoyal Australian Air Force has an airworthy replica R.E.8, built in 2012 and painted in late WW1 eraAustralian Flying Corps livery. It was previously part of theRAAF Museum collection and as of 2021 is with theAir Force Heritage Squadron.
Data fromThe Royal Aircraft Factory[27]
General characteristics
Performance
Armament
Aircraft of comparable role, configuration, and era
Related lists
