Rope start (also calledripcord[citation needed],pull start[citation needed], orrewind start[citation needed]) is a method of starting aninternal combustion engine, usually on small machines, such aslawn mowers,chainsaws,grass trimmers,ultralight aircraft, smalloutboard motors and portableengine-generators. Also used on some small vehicles such as smallgo-karts,minibikes, and smallATVs.
This starter mechanism comprises a rope, with a grip at the end, moulded rope reels and a spring. The rope is coiled within a reel which is held under spring tension within an outer reel. This reel assembly is in contact with one end of thecrankshaft through aratcheting mechanism (specifically, afreewheel clutch). When the rope's grip is pulled, the rope uncoils, tensions the spring, engages the clutch and turns the crankshaft, spinning it to crank or start the engine before the end of the pull stroke. The running of the engine then disengages the clutch. When the user releases the grip, the spring operated reel retracts the rope, setting it up for the next start operation. This recoiling of the rope (as opposed to the rope detaching) gives the recoil starter its name. (Should the engine fail to start, the stopping of the rope pull also disengages the clutch so the rope can be recoiled). This was created byJacobsen Manufacturing in 1928.[citation needed]
A reel connected to the crankshaft has a notch in it to put a rope through. The rope is wound around the reel and pulled, starting the engine, but once the end of the pull is reached, it comes free, leaving a loose rope in the person's hand. If the engine fails to start on the first pull, the operator has to re-wind it by hand.[citation needed]
A number of features are labelled by manufacturers as "easy start," such as the presence of a primer bulb, an additional elastic/spring element between the starter rope and the crankshaft, a decompression release, or simply an engine which the manufacturer contends is easy to start.[1]
Acompression release feature, found on many modern engines and especially larger 2-strokes, is a valve in the combustion chamber which can be held open while the rope is being pulled, avoiding the need to overcome compression while imparting enough angular momentum for the engine to continue. Once the engine fires on its own and creates a sufficient over-pressure, the mechanism is deactivated so the engine can develop enough compression to run normally.[2][3] Compression release valves may, depending on the design, either be manually opened by the operator or be automatically opened when thechoke is engaged or whenever the engine is not running.[3]