Interstellar formaldehyde (a topic relevant toastrochemistry) was first discovered in 1969 by L. Snyderet al. using theNational Radio Astronomy Observatory.Formaldehyde (H2CO) was detected by means of the 111 - 110 ground state rotational transition at 4830 MHz.[1] On 11 August 2014, astronomers released studies, using theAtacama Large Millimeter/Submillimeter Array (ALMA) for the first time, that detailed the distribution ofHCN,HNC,H2CO, anddust inside thecomae ofcometsC/2012 F6 (Lemmon) andC/2012 S1 (ISON).[2][3]
Formaldehyde was first discovered in interstellar space in 1969 by L. Snyderet al. using theNational Radio Astronomy Observatory. H2CO was detected by means of the 111 - 110ground staterotational transition at 4830 MHz.[4]
Formaldehyde was the firstpolyatomicorganic molecule detected in the interstellar medium and since its initial detection has been observed in many regions of the galaxy.[5] Theisotopic ratio of [12C]/[13C] was determined to be about or less than 50% in thegalactic disk.[6] Formaldehyde has been used to map out kinematic features of dark clouds located nearGould's Belt of local bright stars.[7] In 2007, the first H2CO 6 cmmaser flare was detected.[8] It was a short duration outburst inIRAS 18566 + 0408 that produced a line profile consistent with the superposition of twoGaussian components, which leads to the belief that an event outside the maser gas triggered simultaneous flares at two different locations.[8] Although this was the first maser flare detected, H2CO masers have been observed since 1974 by Downes and Wilson in NGC 7538.[9] Unlike OH, H2O, and CH3OH, only five galactic star forming regions have associated formaldehyde maser emission, which has only been observed through the 110 → 111 transition.[9]
According to Arayaet al., H2CO are different from other masers in that they are weaker than most other masers (such as OH, CH3OH, and H2O) and have only been detected near very young massive stellar objects.[10] Unlike OH, H2O, and CH3OH, only five galactic star forming regions have associated formaldehyde maser emission, which has only been observed through the 110 → 111 transition.[11] Because of the widespread interest in interstellar formaldehyde it has recently been extensively studied, yielding new extragalactic sources, including NGC 253, NGC 520,NGC 660, NGC 891, NGC 2903, NGC 3079, NGC 3628, NGC 6240, NGC 6946, IC 342, IC 860, Arp 55, Arp 220, M82, M83, IRAS 10173+0828, IRAS 15107+0724, and IRAS 17468+1320.[12]
The gas-phase reaction that produces formaldehyde possesses modest barriers and is too inefficient to produce the abundance of formaldehyde that has been observed.[13] One proposed mechanism for the formation is the hydrogenation of CO ice, shown below.[13]
This is the basic production mechanism leading to H2CO; there are several side reactions that take place with each step of the reaction that are based on the nature of the ice on the grain according to David Woon.[13] The rate constant presented is for the hydrogenation of CO. The rate constant for the hydrogenation of HCO was not provided as it was much larger than that of the hydrogenation of CO, likely because HCO is a radical.[14] Awadet al. mention that this is a surface level reaction only and only the monolayer is considered in calculations; this includes the surface within cracks in the ice.[14]
Formaldehyde is relatively inactive in gas phase chemistry in the interstellar medium. Its action is predominantly focused in grain-surface chemistry on dust grains in interstellar clouds.[15][16] Reactions involving formaldehyde have been observed to produce molecules containing C-H, C-O, O-H, and C-N bonds.[16] While these products are not necessarily well known, Schutteet al. believe these to be typical products of formaldehyde reactions at higher temperatures,polyoxymethylene,methanolamine,methanediol, andmethoxyethanol for example (see Table 2[15]). Formaldehyde is believed to be the primary precursor for most of the complex organic material in the interstellar medium, includingamino acids.[16] Formaldehyde most often reacts with NH3, H2O, CH3OH, CO, and itself, H2CO.[15][16] The three dominating reactions are shown below.[15]
There is no kinetic data available for these reactions as the entire reaction is not verified nor well understood. These reactions are believed to take place during warm-up of the ice on grains which releases the molecules to react. These reactions begin at temperatures as low as 40K - 80K but may take place at even lower temperatures.
Note that many other reactions are listed on theUMIST RATE06 database.
Formaldehyde appears to be a useful probe for astrochemists due to its low reactivity in the gas phase and to the fact that the 110 - 111 and 211 - 212 K-doublet transitions are rather clear. Formaldehyde has been used in many capacities and to investigate many systems including,
Above is the rotational spectrum at the ground state vibrational level of H2CO at 30 K. This spectrum was simulated using Pgopher and S-Reduction Rotational constants from Mulleret al.[18] The observed transitions are the 6.2 cm 111 - 110 and 2.1 cm 212 - 211 K-doublet transitions. At right is the rotational energy level diagram. The ortho/para splitting is determined by the parity of Ka, ortho if Ka is odd and para if Ka is even.[17]
