This articleneeds additional citations forverification. Please helpimprove this article byadding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "Comparison of mobile phone standards" – news ·newspapers ·books ·scholar ·JSTOR(August 2007) (Learn how and when to remove this message)

This is a comparison of standards of wireless networking technologies for devices such asmobile phones. A newgeneration of cellular standards has appeared approximately every tenth year since1G systems were introduced in 1979 and the early to mid-1980s.

Global System for Mobile Communications (GSM, around 80–85% market share) andIS-95 (around 10–15% market share) were the two most prevalent 2G mobile communication technologies in 2007.^[1] In 3G, the most prevalent technology wasUMTS withCDMA-2000 in close contention.

All radio access technologies have to solve the same problems: to divide the finiteRF spectrum among multiple users as efficiently as possible. GSM usesTDMA andFDMA for user and cell separation. UMTS, IS-95 and CDMA-2000 useCDMA.WiMAX andLTE useOFDM.

• Time-division multiple access (TDMA) provides multiuser access by chopping up the channel into sequential time slices. Each user of the channel takes turns to transmit and receive signals. In reality, only one person is actually using the channel at a specific moment. This is analogous totime-sharing on a large computer server.
• Frequency-division multiple access (FDMA) provides multiuser access by separating the used frequencies. This is used in GSM to separate cells, which then use TDMA to separate users within the cell.
• Code-division multiple access (CDMA) This uses adigital modulation calledspread spectrum which spreads the voice data over a very wide channel inpseudorandom fashion using a user or cell specific pseudorandom code. The receiver undoes the randomization to collect the bits together and produce the original data. As the codes are pseudorandom and selected in such a way as to cause minimal interference to one another, multiple users can talk at the same time and multiple cells can share the same frequency. This causes an added signal noise forcing all users to use more power, which in exchange decreases cell range and battery life.
• Orthogonal frequency-division multiple access (OFDMA) uses bundling of multiple small frequency bands that are orthogonal to one another to provide for separation of users. The users are multiplexed in the frequency domain by allocating specific sub-bands to individual users. This is often enhanced by also performing TDMA and changing the allocation periodically so that different users get different sub-bands at different times.

In theory, CDMA, TDMA and FDMA have exactly the same spectral efficiency but practically, each has its own challenges – power control in the case of CDMA, timing in the case of TDMA, and frequency generation/filtering in the case of FDMA.

For a classic example for understanding the fundamental difference of TDMA and CDMA, imagine a cocktail party where couples are talking to each other in a single room. The room represents the available bandwidth:

TDMA: A speaker takes turns talking to a listener. The speaker talks for a short time and then stops to let another couple talk. There is never more than one speaker talking in the room, no one has to worry about two conversations mixing. The drawback is that it limits the practical number of discussions in the room (bandwidth wise).

CDMA: any speaker can talk at any time; however each uses a different language. Each listener can only understand the language of their partner. As more and more couples talk, the background noise (representing thenoise floor) gets louder, but because of the difference in languages, conversations do not mix. The drawback is that at some point, one cannot talk any louder. After this if the noise still rises (more people join the party/cell) the listener cannot make out what the talker is talking about without coming closer to the talker. In effect, CDMA cell coverage decreases as the number of active users increases. This is called cell breathing.

Source:^[4]

• Less signal deterioration inside buildings.
• Ability to userepeaters.
• Talktime is generally higher in GSM phones due to the pulse nature of transmission.
• The availability ofSubscriber Identity Modules allows users to switch networks and handsets at will, aside from asubsidy lock.
• GSMcovers virtually all parts of the world so internationalroaming is not a problem.
• The much bigger number ofsubscribers globally creates a betternetwork effect for GSM handset makers, carriers and end users.

• Interferes with some electronics, especially certain audio amplifiers.
• Intellectual property is concentrated among a few industry participants, creating barriers to entry for new entrants and limiting competition among phone manufacturers. Situation is however worse in CDMA-based systems like IS-95, where Qualcomm is the major IP holder.^{[citation needed]}
• GSM has a fixed maximum cell site range of 120 km,^[5] which is imposed bytechnical limitations.^[6] This is expanded from the old limit of 35 km.

• Capacity is IS-95's biggest asset; it can accommodate more users perMHz ofbandwidth than any other technology.
• Has no built-in limit to the number of concurrent users.
• Uses precise clocks that do not limit the distance a tower can cover.^[7]
• Consumes less power and covers large areas so cell size in IS-95 is larger.
• Able to produce a reasonable call with lower signal (cell phone reception) levels.
• Usessoft handoff, reducing the likelihood of dropped calls.
• IS-95's variable rate voice coders reduce the rate being transmitted when speaker is not talking, which allows the channel to be packed more efficiently.
• Has a well-defined path to higher data rates.

• Most technologies are patented and must be licensed fromQualcomm.
• Breathing of base stations, where coverage area shrinks under load. As the number of subscribers using a particular site goes up, the range of that site goes down.
• Because IS-95 towers interfere with each other, they are normally installed on much shorter towers. Because of this, IS-95 may not perform well in hilly terrain.
• USSD, PTT, concatenated/E-sms are not supported by IS-95/CDMA
• IS-95 covers a smaller portion of the world, and IS-95 phones are generally unable to roam internationally.
• Manufacturers are often hesitant to release IS-95 devices due to the smaller market, so features are sometimes late in coming to IS-95 devices.
• Even barringsubsidy locks, CDMA phones are linked byESN to a specific network, thus phones are typically not portable across providers.

This graphic compares the market shares of the different mobile standards.

In a fast-growing market, GSM/3GSM (red) grows faster than the market and is gaining market share, the CDMA family (blue) grows at about the same rate as the market, while other technologies (grey) are being phased out

As a reference, a comparison of mobile and non-mobile wireless Internet standards follows.

Parts of this article (those related to template) need to beupdated. Please help update this article to reflect recent events or newly available information.(November 2018)

Notes: All speeds are theoretical maximums and will vary by a number of factors, including the use of external antennas, distance from the tower and the ground speed (e.g. communications on a train may be poorer than when standing still). Usually the bandwidth is shared between several terminals. The performance of each technology is determined by a number of constraints, including thespectral efficiency of the technology, the cell sizes used, and the amount of spectrum available.

For more comparison tables, seebit rate progress trends,comparison of mobile phone standards,spectral efficiency comparison table andOFDM system comparison table.

• Advanced Mobile Phone System
• Car phone
• List of wireless network protocols
• Spectral efficiency comparison table
• SMS – contain the content of its standardization

• Mobile telecommunications standards
• Lists of standards
• Computing comparisons

• Articles with short description
• Short description is different from Wikidata
• Use dmy dates from April 2021
• Articles needing additional references from August 2007
• All articles needing additional references
• All articles with unsourced statements
• Articles with unsourced statements from January 2008
• Wikipedia articles in need of updating from November 2018
• All Wikipedia articles in need of updating