 | This articleneeds additional citations forverification. Please helpimprove this article byadding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "Boiler feedwater pump" – news ·newspapers ·books ·scholar ·JSTOR(April 2012) (Learn how and when to remove this message) |
Aboiler feedwater pump is a specific type ofpump used to pumpfeedwater into asteam boiler. The water may be freshly supplied or returningcondensate produced as a result of the condensation of the steam produced by the boiler. These pumps are normally high pressure units that take suction from a condensate return system and can be of thecentrifugal pump type or positive displacement type.
 | This articleis missing information about turbine-driven feedwater pumps. Please expand the article to include this information. Further details may exist on thetalk page.(October 2016) |
Feedwater pumps range in size up to many kilowatts and theelectric motor is usually separated from the pump body by some form of mechanical coupling. Large industrialcondensate pumps may also serve as the feedwater pump. In either case, to force the water into the boiler, the pump must generate sufficient pressure to overcome the steam pressure developed by the boiler. This is usually accomplished through the use of a centrifugal pump.Another common form of feedwater pump runs constantly and is provided with a minimum flow device to stop overpressuring the pump on low flows. The minimum flow usually returns to the tank or deaerator.
Mechanical seals of boiler feedwater pumps often show signs of electrical corrosion. The relative movement between the sliding ring and the stationary ring provokes static charging which is not diverted due to the very low conductivity of the boiler water (below one micro-Siemens per cm [μS/cm]). Within short periods of operation – in some cases, only a few hundred operational hours – pieces having the size of fingertips break off from the sliding and/or the stationary ring and cause rapid increases in leakage current. Diamond-coated (DLC)mechanical seals avoid this problem and extend durability remarkably.[1]
Steam locomotives and thesteam engines used on ships and stationary applications such aspower plants also require feedwater pumps. In this situation, though, the pump was often powered using a small steam engine that ran using the steam produced by the boiler. A means had to be provided, of course, to put the initial charge of water into the boiler (before steam power was available to operate the steam-powered feedwater pump). The pump was often a positive displacement pump that had steam valves and cylinders at one end and feedwater cylinders at the other end; no crankshaft was required.
A duplex steam pump has two sets of steam and water cylinders. They are not physically connected but the steam valves on the first pump are operated by the movement of the second pump's piston rod, and vice versa. The result is that there are no "dead spots" and the pump is always self-starting.[2]
Aninjector pump uses theVenturi effect and steam condensation to deliver water to a boiler.[3]
