Diffusion current is acurrent in asemiconductor caused by thediffusion ofcharge carriers (electrons and/orelectron holes). This is the current which is due to the transport of charges occurring because of non-uniform concentration of charged particles in a semiconductor. The drift current, by contrast, is due to the motion of charge carriers due to the force exerted on them by an electric field. Diffusion current can be in the same or opposite direction of a drift current. The diffusion current and drift current together are described by thedrift–diffusion equation.^[1]

It is necessary to consider the part of diffusion current when describing many semiconductor devices. For example, the current near thedepletion region of ap–n junction is dominated by the diffusion current. Inside the depletion region, both diffusion current and drift current are present. At equilibrium in a p–n junction, the forward diffusion current in the depletion region is balanced with a reverse drift current, so that the net current is zero.

Thediffusion constant for a doped material can be determined with theHaynes–Shockley experiment. Alternatively, if the carrier mobility is known, the diffusion coefficient may be determined from theEinstein relation on electrical mobility.

The following table compares the two types of current:

Diffusion current	Drift current
Diffusion current = the movement caused by variation in the carrier concentration.	Drift current = the movement caused by electric fields.
Direction of the diffusion current depends on the slope of the carrier concentration.	Direction of the drift current is always in the direction of the electric field.
ObeysFick's law:${\displaystyle J=-qD\frac{d\rho }{dx}}$	ObeysOhm's law:${\displaystyle J=q\rho \mu E}$

No external electric field across the semiconductor is required for a diffusion current to take place. This is because diffusion takes place due to the change in concentration of the carrier particles and not the concentrations themselves. The carrier particles, namely the holes and electrons of a semiconductor, move from a place of higher concentration to a place of lower concentration. Hence, due to the flow of holes and electrons there is a current. This current is called the diffusion current. The drift current and the diffusion current make up the total current in the conductor. The change in the concentration of the carrier particles develops a gradient. Due to this gradient, an electric field is produced in the semiconductor.

In a region where n and p vary with distance, a diffusion current is superimposed on that due to conductivity. This diffusion current is governed byFick's law:

${\displaystyle F=-D_{\text{e}}\mathrm{\nabla }n}$

where:

F is flux.

D_e is thediffusion coefficient or diffusivity

${\displaystyle \mathrm{\nabla }n}$ is the concentration gradient of electrons

there is a minus sign because the direction of diffusion is opposite to that of the concentration gradient

The diffusion coefficient for a charge carrier is related to its mobility by theEinstein relation:

${\displaystyle D_{\text{e}}=\frac{{\mu }_{\text{e}}{k}_{\text{B}}T}{e}}$

where:

k_B is theBoltzmann constant

T is theabsolute temperature

e is the electrical charge of an electron

Now let's focus on the diffusive current in one-dimension along the x-axis:

${\displaystyle F_x=-D_{\text{e}}\frac{dn}{dx}}$

The electron current density J_e is related to flux,F, by:

${\displaystyle J_{\text{e}}=-eF}$

Thus

${\displaystyle J_{\text{e}}=+e{D}_{\text{e}}\frac{dn}{dx}}$

Similarly for holes:

${\displaystyle J_{\text{h}}=-e{D}_{\text{h}}\frac{dp}{dx}}$

Notice that for electrons the diffusive current is in the same direction as the electron density gradient because the minus sign from the negative charge andFick's law cancel each other out. However, holes have positive charges and therefore the minus sign from Fick's law is carried over.

Superimpose the diffusive current on thedrift current to get

${\displaystyle J_{\text{e}}=e{\mu }_{\text{e}}nE+e{D}_{\text{e}}\frac{dn}{dx}}$ for electrons

and

${\displaystyle J_{\text{h}}=e{\mu }_{\text{h}}pE-e{D}_{\text{h}}\frac{dp}{dx}}$ for holes

Consider electrons in a constant electric fieldE. Electrons will flow (i.e. there is a drift current) until the density gradient builds up enough for the diffusion current to exactly balance the drift current. So at equilibrium there is no net current flow:

${\displaystyle e{\mu }_{\text{e}}nE+e{D}_{\text{e}}\frac{dn}{dx}=0}$

This article containsformulas that need descriptions. Please helpclarify variables, symbols, and constants.(June 2012) (Learn how and when to remove this message)

To derive the diffusion current in a semiconductor diode, the depletion layer must be large compared to the mean free path.One begins with the equation for the netcurrent densityJ in a semiconductor diode,

${\displaystyle J=qn\mu E+qD\frac{dn}{dx}}$

1

whereD is thediffusion coefficient for the electron in the considered medium,n is the number of electrons per unit volume (i.e. number density),q is the magnitude of charge of an electron,μ is electron mobility in the medium, andE = −dΦ/dx (Φ potential difference) is theelectric field as thepotential gradient of theelectric potential. According to theEinstein relation on electrical mobility${\displaystyle D=\mu V_t}$ and${\displaystyle V_t=kT/q}$. Thus, substitutingE for the potential gradient in the above equation (1) and multiplying both sides with exp(−Φ/V_t), (1) becomes:

${\displaystyle J{e}^{-\mathrm{\Phi }/V_t}=qD\left(\frac{-n}{V_t}\ast \frac{d\mathrm{\Phi }}{dx}+\frac{dn}{dx}\right)e^{-\mathrm{\Phi }/V_t}=qD\frac{d}{dx}(n{e}^{-\mathrm{\Phi }/V_t})}$

2

Integrating equation (2) over the depletion region gives

${\displaystyle J=\frac{qDn{e}^{-\mathrm{\Phi }/V_t}{|}_0^{x_d}}{{\int }_0^{x_d}{e}^{-\mathrm{\Phi }/V_t}dx}}$

which can be written as

${\displaystyle J=\frac{qD{N}_c{e}^{-{\mathrm{\Phi }}_B/V_t}\left[e^{V_a/V_t}-1\right]}{{\int }_0^{x_d}{e}^{-{\mathrm{\Phi }}^{\ast }/V_t}dx}}$

3

where

${\displaystyle {\mathrm{\Phi }}^{\ast }={\mathrm{\Phi }}_B+{\mathrm{\Phi }}_i-V_a}$

The denominator in equation (3) can be solved by using the following equation:

${\displaystyle \mathrm{\Phi }=-\frac{q{N}_d}{2E_s(x-x_d{)}^2}}$

Therefore, Φ* can be written as:

${\displaystyle {\mathrm{\Phi }}^{\ast }=\frac{q{N}_{d}x}{E_s}\left(x_d-\frac{x}{2}\right)=({\mathrm{\Phi }}_i-V_a)\frac{x}{x_d}}$

4

Since thex ≪x_d, the term (x_d −x/2) ≈x_d, using this approximation equation (3) is solved as follows:

${\displaystyle {\int }_0^{x_d}{e}^{-{\mathrm{\Phi }}^{\ast }/V_t}dx=x_d\frac{{\mathrm{\Phi }}_i-V_a}{V_t}}$,

since (Φ_i −V_a) >V_t. One obtains the equation of current caused due to diffusion:

${\displaystyle J=\frac{q_{2}D{N}_c}{V_t}{\left[\frac{2q}{E_s}({\mathrm{\Phi }}_i-V_a)N_d\right]}^{1/2}{e}^{-{\mathrm{\Phi }}_B/V_t}(e^{V_a/V_t}-1)}$

5

From equation (5), one can observe that the current depends exponentially on the input voltageV_a, also the barrier height Φ_B. From equation (5),V_a can be written as the function of electric field intensity, which is as follows:

${\displaystyle E_{\mathrm{m}\mathrm{a}\mathrm{x}}={\left[\frac{2q}{E_s}({\mathrm{\Phi }}_i-V_a)N_d\right]}^{1/2}}$

6

Substituting equation (6) in equation (5) gives:

${\displaystyle J=q\mu E_{\mathrm{m}\mathrm{a}\mathrm{x}}{N}_c{e}^{-{\mathrm{\Phi }}_B/V_t}(e^{V_a/V_t}-1)}$

7

From equation (7), one can observe that when a zero voltage is applied to the semi-conductor diode, the drift current totally balances the diffusion current. Hence, the net current in a semiconductor diode at zero potential is always zero.

The equation above can be applied to model semiconductor devices. When the density of electrons is not in equilibrium, diffusion of electrons will occur. For example, when a bias is applied to two ends of a chunk of semiconductor, or a light is shining in one place (see right figure), electrons will diffuse from high density regions (center) to low density regions (two ends), forming a gradient of electron density. This process generates diffusion current.

• Alternating current
• Conduction band
• Convection–diffusion equation
• Direct current
• Drift current
• Free electron model
• Random walk
• Maximal entropy random walk – diffusion in agreement with quantum predictions

• Encyclopaedia of Physics (2nd Edition),R.G. Lerner, G.L. Trigg, VHC publishers, 1991, ISBN (Verlagsgesellschaft) 3-527-26954-1, ISBN (VHC Inc.) 0-89573-752-3
• Concepts of Modern Physics (4th Edition), A. Beiser, Physics, McGraw-Hill (International), 1987,ISBN 0-07-100144-1
• Solid State Physics (2nd Edition), J.R. Hook, H.E. Hall, Manchester Physics Series, John Wiley & Sons, 2010,ISBN 978 0 471 92804 1
• Ben G. Streetman, Santay Kumar Banerjee;Solid State Electronic Devices (6th Edition), Pearson International Edition; pp. 126–135.
• "Differences between diffusion current".Diffusion. Archived fromthe original on 13 August 2017. Retrieved10 September 2011.
• "Carrier Actions of Diffusion Current".Diffusion. Archived fromthe original on 10 August 2011. Retrieved11 October 2011.
• "derivation of difusion current". Archived fromthe original on 14 December 2011. Retrieved15 October 2011.

• Semiconductors
• Electric current
• Charge carriers

• Articles with short description
• Short description is different from Wikidata
• Articles needing expert attention from June 2012
• Wikipedia articles needing clarification from June 2012