I just got an AVR ASP mkII external programmer and I am unsuccessfully trying to program my arduino with it.All the settings in the IDE are correct. This is the error message that I am getting:...

I got a Pocket AVR Programmer.https://learn.sparkfun.com/tutorials/pocket-avr-programmer-hookup-guideI hooked it up on Ubuntu Linux, opened up a sketch in the Arduino IDE, selected Programmer: ...

I bought a couple of ESP32CAMs from aliexpress... althought the listing shows them with two buttons, I got the ESP32-CAM-MB boards with just the reset button...I have my computer set up to dual boot ...

Are there any options for programming an STM32 black-pill from the Arduino IDE without first having to manually push buttons to go into DFU mode or having to buy an ST-Link device?A solution that ...

I am using the Arduino IDE as an ISP programmer to program my ATtiny44 IC. Unfortunately, I ran out of pins, so I want to use the reset pin as I/O. I read several articles online that says it is ...

Currently I am using avrdude and I'm programming my atmega328p chip via the spi pins by pulling the RESET pin low (spidev programmer).In my project I'm using predominantly i2c and this the only place ...

I have a Spark Fun Pro Micro (ATmega32U4) without a USB connection (it was broken off at an earlier point) that I want to use to duplicate a prototype running on another Pro Micro.How can I upload a ...

I took a look at a barebones Arduino schematic.It had three different ways of programming the chip.The first interface is for programming through SPI (For example with "Pocket AVR Programmer&...

The question is meant as in, can I lock myself out of the Arduino using the bootloader, if I flash a hex file that doesn't contain the bootloader?Or does the bootloader automatically add the flashed ...

I am getting an error while trying to upload programs to the Attiny85 through a USBTinyISP programmer, found here. Unfortunately, it isn't working. Following this tutorial for connecting the board and ...

I want to use the Arduino IDE using a raspberry pi with raspbian OS because it's the only way I can read a Digispark usb (I don't have 2.0 usb ports in my laptop so I can't read the usb with it).I ...

Hi my USB to UART bridge (CP2102) seems to be broken on one of my NodeMCU Dev Boards with ESP8266.It seems to be just that specific board since all other boards that I have can be flashed without ...

I just have a complex program that runs on a NANO. Now when I use my printlns for debugging I am running out of memory.I read about using a programmer to get rid of the bootloader that uses 2K space ...

I currently use a Pololu USB AVR Programmer v2.1 for programming 328p chips and I really like it. The ability to have ISP and Serial in one physical device, enumerating as two separate COM ports on ...

I have an Arduino Due board. I can successfully upload code to it using Arduino upload via USB.However I am also exploring another approach, which is to upload code via Atmel studio using an Atmel ...