I have an Arduino Mega2560 and a Raspberry Pi hooked up through I2C. The Pi is acting as the master, while the Arduino is the slave. While sending data over I2C, the int message gets messed up and will either send the address or the data. Then I can't even receive any useful data from the Arduino.
So if I turn the receiving function off it sends the data just fine, but when I ask the Pi to start receiving data again it slows down the entire bus and data starts conflicting between the Pi and Arduino. Also it only happens with the Arduino. Every other device works flawlessly.
Here's what my code looks like on the Pi side. I'm using SMBus to send and receive bytes. I didn't bother to put up code for it because I don't have the source code for SMBus. I just trust that they work because my other I2C devices work without a hitch.
while True: #if alternating == true then get the imu if not then get the motor speed if alternating == True: try: #need the try because an error will stop the program completely ypr = IMU.getYPR() yaw = int(ypr['yaw'] * 180 / math.pi) savedYaw = yaw except: yaw = savedYaw #print "exception" pass #write yaw to arduino i2c.writeByte(yaw) alternating = False else: #start reading data from arduino #readArduino() alternating = True passThen on the Arduino side these are myonReceive andonRequest functions:
void readPI(int byteC) { if(Wire.available()) { reference = Wire.read(); } pid1.getReference(reference); pid2.getReference(reference);}void sendPI() { int values[] = {(int)out, (int)outReversed }; Wire.write(values[count]); count++; if(count > 1) { count = 0; }}Is there something about the Arduino that I don't know? Maybe it's a timing issue? Is there a way to set up registers? I can either receive or send, but I can't do both, and Googling the problem only leads to an example of someone sending 1 - 9 over the Pi. I can't find examples of anyone actually doing something complicated with an Arduino and a Rasp Pi over I2C. Any and all help would be amazing!
1 Answer1
I find your onRequest function obscure:
void sendPI(){ int values[] = {(int)out, (int)outReversed }; Wire.write(values[count]); count++; if(count > 1){ count = 0; } }Why only send one byte? I think you have a number of problems:
The size of
inton the Arduino Uno is 2 bytes, on a Pi it is 4 bytes. So there is a mismatch there for a start.Wire.write(written like that) sends one byte, so that is only going to be half of yourint. So that is even less.It isn't obvious what the Pi end is doing, but to make the
intsizes match, I would be sending the lot in one hit like this:void sendPI(){ long values[] = {(int)out, (int)outReversed }; Wire.write((byte *) &values, sizeof values); }Now you just read 8 bytes on the Pi (two ints).
- well that didn't fix the problem I was having, but it got me on the right track. The i2c library i'm using for the Rpi writes a value as it reads the arduino. I had thought that it had just strictly read or write the i2c bus. So I was writing and reading bad values all over the place. it's now fixed.Ximidar– Ximidar2015-08-18 06:30:23 +00:00CommentedAug 18, 2015 at 6:30
- 1If that fixed the problem please accept the answer, so that Stack Exchange doesn't keep throwing it back as an unanswered question. Thanks!2016-04-12 05:49:12 +00:00CommentedApr 12, 2016 at 5:49
Explore related questions
See similar questions with these tags.