| |||
| Names | |||
|---|---|---|---|
| Preferred IUPAC name 1,2-Dichloro-1,1,2,2-tetrafluoroethane | |||
| Other names R-114, CFC-114, halon 242, cryofluorane, Freon 114, Genetron 114, Refrigerant 114 | |||
| Identifiers | |||
| |||
3D model (JSmol) | |||
| ChEMBL | |||
| ChemSpider |
| ||
| ECHA InfoCard | 100.000.853 | ||
| EC Number |
| ||
| RTECS number |
| ||
| UNII | |||
| UN number | 1958 | ||
| |||
| |||
| Properties | |||
| C2Cl2F4 | |||
| Molar mass | 170.92 g/mol | ||
| Appearance | colorless gas[1] | ||
| Odor | faint,ether-like (high concentrations)[1] | ||
| Density | 1.455 g/cm3 | ||
| Melting point | −94 °C (−137 °F; 179 K) | ||
| Boiling point | 3.5 °C (38.3 °F; 276.6 K) | ||
| 0.01%[1] | |||
| Vapor pressure | 1.9 atm (21°C)[1] | ||
| Hazards | |||
| Occupational safety and health (OHS/OSH): | |||
Main hazards | Ozone depletor | ||
| GHS labelling: | |||
 | |||
| Warning | |||
| H420 | |||
| P410+P403,P502 | |||
| Flash point | nonflammable[1] | ||
| Lethal dose or concentration (LD, LC): | |||
LC50 (median concentration) | 720,000 ppm (rat, 30 min) 700,000 ppm (mouse, 30 min) 750,000 ppm (rabbit, 30 min)[2] | ||
| NIOSH (US health exposure limits): | |||
PEL (Permissible) | TWA 1000 ppm (7000 mg/m3)[1] | ||
REL (Recommended) | TWA 1000 ppm (7000 mg/m3)[1] | ||
IDLH (Immediate danger) | 15000 ppm[1] | ||
Except where otherwise noted, data are given for materials in theirstandard state (at 25 °C [77 °F], 100 kPa). | |||
1,2-Dichlorotetrafluoroethane, orR-114, also known ascryofluorane (INN), is achlorofluorocarbon (CFC) with the molecular formula ClF2CCF2Cl. Its primary use has been as arefrigerant. It is a non-flammable gas with a sweetish,chloroform-like odor with thecritical point occurring at 145.6 °C and 3.26 MPa. When pressurized or cooled, it is a colorless liquid. It is listed on theIntergovernmental Panel on Climate Change's list of ozone depleting chemicals, and is classified as aMontreal Protocol Class I, group 1 ozone depleting substance.[3]
When used as a refrigerant, R-114 is classified as a medium pressure refrigerant.
TheU.S. Navy uses R-114 in itscentrifugal chillers in preference toR-11 to avoid air and moisture leakage into the system. While the evaporator of an R-11 charged chiller runs at a vacuum during operation, R-114 yields approximately 0 psig operating pressure in the evaporator.
Manufactured and sold R-114 was usually mixed with the non symmetrical isomer1,1-dichlorotetrafluoroethane (CFC-114a), as separation of the two isomers is difficult.[4]
Aside from its immense environmental impacts, R114, like most chlorofluoroalkanes, forms phosgene gas when exposed to a naked flame.[5]
| Authority control databases: National |
|---|
