Movatterモバイル変換


[0]ホーム

URL:


PC Engines Home
 CompactFlash cards
cf4slc /cf8slcPC Engines offers CompactFlash cards builtusing high endurance SLC flash.

 IDE to CompactFlash adapters
SummaryIndustry standard CompactFlash cards can be used as a solid state replacementfor IDE / PATA hard disks. This means lower power, fast readaccess time and high reliability. On most systems, a CompactFlash cardwill look just like a regular IDE disk drive to the system BIOSand operating system. No special device drivers are required.
NoteDue to limitations of the CompactFlash IDE mode, hot insertion of cardsis NOT supported.
cf1ehReplacement for 3.5" hard disk drives, 40 pin IDEconnector. Mounting hole locations same as the bottom holes of a harddisk drive. Board size is 2" x 4". Jumper configuration for master or slave.

cf1efSame, with a floppy power connector.
cf2gReplacement for 2.5" hard disk drives, 44 pin IDE connector.The 44 pin connector includes power.Designed for use in notebook drive traysor with a 44 pin cable. Four M3 screw mounts from below. Master / slaveconfigured by cable select (remove R1, install jumper to hardwire formaster).

cf2hSimilar to cf2g, with added mounting points to replace creaky legacyhard drives in voice mail systems and industrial controls.
cf5hReplacement for 3.5" hard disk drives, plugs directlyonto a 40 pin IDE connector. Uses a floppy power connector. Hardwired asmaster. Not recommended for high vibration environments.

cf5hsSame as cf5h, parallel to the system board. This will only fit in someapplications.
 mSATA SSD modules
msata16g /msata30b /msata120cPC Engines offers small capacitymSATA solid state disk modules built using MLC flashand Phison / Silicon Motion controllers.

 SD cards
sd4bPC Engines offers SD cards built using MLC flash, operated in higherendurance and performance pseudo SLC (pSLC) mode.

© 2002-2023 PC Engines GmbH. All rights reserved.

[8]ページ先頭

©2009-2025 Movatter.jp