These evaporation maps show the amount of water which evaporates from an open pan, distributed across Australia.

Product Code: IDCJCM0006
Unless otherwise noted, all maps and graphs in this page are licensed under theCreative Commons Attribution Australia Licence
These maps show the average amount of water which evaporates from an open pan each month,season and annually. Evaporation is measured by the use of a"class A evaporation pan".
Average annual evaporation is calculated by adding evaporation totals over a specified period (1975 to 2005) and dividing by the number of years in that period (29 years in this case). Similarly, average monthly and seasonal evaporation are calculated by adding monthly or seasonal evaporation totals and dividing by the number of years in the specified period. The rate of evaporation depends on factors such as cloudiness, air temperature and wind speed. Measurements are made by the addition or subtraction of a known amount of water, which then tells us how much water has evaporated from the pan.
These maps are indicative of the amount of water evaporating from bare ground or open water, evaporation from land surfaces covered by vegetation is better estimated byevapotranspiration.
Areas in central Australia are very dry, and therefore have a high rate of evaporation. In contrast, coastal areas tend to have a lower evaporation rate as a result of their proximity to a large water source. Compare these maps to the maps showing averagerainfall andhumidity. Areas with low rainfall and low humidity tend to have a high evaporation rate, whilst areas with high rainfall and high humidity tend to have a low evaporation rate.
This page was created at on
©Copyright Commonwealth of Australia , Bureau of Meteorology (ABN 92 637 533 532) |Disclaimer |Privacy |Accessibility