Movatterモバイル変換

TELINIT(8)                          telinitTELINIT(8)NAME       telinit - Change SysV runlevelSYNOPSIS       telinit [OPTIONS...] {COMMAND}DESCRIPTION       telinit may be used to change the SysV system runlevel. Since the       concept of SysV runlevels is obsolete the runlevel requests will be       transparently translated into systemd unit activation requests.OPTIONS       The following options are understood:       --help           Print a short help text and exit.       --no-wall           Do not send wall message before reboot/halt/power-off.       The following commands are understood:       0           Power-off the machine. This is translated into an activation           request for poweroff.target and is equivalent to systemctl           poweroff.       6           Reboot the machine. This is translated into an activation request           for reboot.target and is equivalent to systemctl reboot.       2, 3, 4, 5           Change the SysV runlevel. This is translated into an activation           request for runlevel2.target, runlevel3.target, ... and is           equivalent to systemctl isolate runlevel2.target, systemctl isolate           runlevel3.target, ...       1, s, S           Change into system rescue mode. This is translated into an           activation request for rescue.target and is equivalent to systemctl           rescue.       q, Q           Reload daemon configuration. This is equivalent to systemctl           daemon-reload.       u, U           Serialize state, reexecute daemon and deserialize state again. This           is equivalent to systemctl daemon-reexec.EXIT STATUS       On success, 0 is returned, a non-zero failure code otherwise.NOTES       This is a legacy command available for compatibility only. It should       not be used anymore, as the concept of runlevels is obsolete.SEE ALSOsystemd(1),systemctl(1),wall(1)systemd 245TELINIT(8)