Most crossings around the world are marked by some form ofsaltire (Saint Andrew's cross, orcrossbuck) to warn road users about a level crossing or a level crossing with no barriers. This sign is on a level crossing in Wales.A level crossing atHoylake,Merseyside, England, with a train passing
Alevel crossing is an intersection where arailway line crosses a road,path, or (in rare situations) airport runway, at the same level,[1] as opposed to the railway line or the road etc. crossing over or under using anoverpass ortunnel. The term also applies when alight rail line with separateright-of-way orreserved track crosses a road in the same fashion. Other names includerailway level crossing,[1]railway crossing (chiefly international),grade crossing orrailroad crossing (chiefly American),[2]road through railroad,criss-cross,train crossing, andRXR (abbreviated).
There are more than 100,000 level crossings in Europe and more than 200,000 in North America.
Road-grade crossings are considered incompatible with high-speed rail[3] and are virtually non-existent in European high-speed train operations.[4]
The types of early level crossings varied by location, but often they had aflagman in a nearby booth who, on the approach of a train, would wave a red flag or lantern to stop all traffic and clear the tracks. This was a dangerous job that cost the lives of gatekeepers or their family members, as the train was not given enough time to stop.[5]
Video of barriers descending and a train passing at an active level crossing inJapan, 2022
Gated crossings became commonplace in many areas, as they protected the railway from people trespassing and livestock, and they protected the users of the crossing when closed by the signalman/gateman. In the second quarter of the 20th century[citation needed], manual or electricalclosable gates that barricaded the roadway started to be introduced, intended to be a complete barrier against intrusion of any road traffic onto the railway. Automatic crossings are now commonplace in some countries as motor vehicles replacedhorse-drawn vehicles and the need for animal protection diminished with time. Full-, half- or no-barrier crossings superseded gated crossings, although crossings of older types can still be found in places. In rural regions with sparse traffic, the least expensive type of level crossing to operate is one without flagmen or gates, with only a warning sign posted. This type has been common across North America and in many developing countries.
Some international rules have helped to harmonise level crossing. For instance, the1968 Vienna Convention states (chapter 3, article 23b) that:
"one or two blinking red light indicates a car should stop; if they are yellow the car can pass with caution".[6]
Article 27 suggests stop lines at level crossings.
Article 33, 34, 35 and 36 are specific to level crossings, because level crossings are recognized as dangerous.
Article 35 indicates a cross should exist[clarification needed] when there is no barrier or lights.
This has been implemented in many countries, including countries which are not part of the Vienna Convention.
Trains have a much largermass relative to their braking capability, and thus a far longerbraking distance than road vehicles. With rare exceptions, trains do not stop at level crossings but rely on road vehicles and pedestrians to clear the tracks in advance. There have been several accidents in which a heavy load on a slow road transporter has not cleared the line in time, such as theHixon rail crash.
Level crossings constitute a significant safety concern internationally. On average, each year around 400 people in theEuropean Union[8] and over 300 in the United States[9] are killed in level crossing accidents. Collisions can occur with vehicles as well as pedestrians; pedestrian collisions are more likely to result in a fatality.[10] Among pedestrians, young people (5–19 years), older people (60 years and over), and males are considered to be higher risk users.[11] On some commuter lines most trains may slow to stop at a station, but express or freight trains will pass through stations at high speed without slowing.
As far as warning systems for road users are concerned, level crossings either have "passive" protection, in the form of various types of warning signs, or "active" protection, using automatic warning devices such as flashing lights, warning sounds, and barriers or gates.[8] In the 19th century and for much of the 20th, a sign warning "Stop, look, and listen" (or similar wording) was the sole protection at most level crossings. Fewer collisions take place at level crossings with active warning systems, and active protection is widely available.[12] Modern radar sensor systems can detect if level crossings are free of obstructions as trains approach. These improve safety by not lowering crossing barriers that may trap vehicles or pedestrians on the tracks, while signalling trains to brake until the obstruction clears. However, they cannot prevent a vehicle from moving out onto the track once it is far too late for the locomotive to slow even slightly.[13]
Due to the increase in road and rail traffic as well as for safety reasons, level crossings are increasingly being removed. As an example,Melbourne is as of 2024[update], planning toclose 110 level crossings by 2030 and (due to the proximity of some stations) rebuild 51 stations.[citation needed]
Atrailway stations, a pedestrian level crossing is sometimes provided to allow passengers to reach other platforms in the absence of an underpass or bridge, or for disabled access. Wherethird rail systems have level crossings, there is a gap in the third rail over the level crossing, but this does not necessarily interrupt the power supply to trains since they may have current collectors on multiple cars.
Level crossing inGermany with an egg-shaped radar sensor for detecting obstacles on the crossing
Source:Eurostat: The rail accident data are provided to Eurostat by theEuropean Railway Agency (ERA). The ERA manages and is responsible for the entire data collection. The Eurostat data constitute a part of the data collected by ERA and are part of the so-called Common Safety Indicators (CSIs).Note: Since 2010, use of national definitions is no longer permitted: 2010 CSI data represent the first fully harmonized set of figures.
Traffic signal-controlled intersections next to level crossings on at least one of the roads in the intersection usually featuretraffic signal preemption.[16] In the US, approaching trains activate a routine where, before the road lights and barriers are activated, all traffic signal phases go to red, except for the signal immediately after the crossing, which turns green (or flashing yellow) to allow traffic on the tracks to clear (in some cases, there are auxiliary traffic signals prior to the railroad crossing which will turn red, keeping new traffic from crossing the tracks. This is in addition to the flashing lights on the crossing barriers). After enough time to clear the crossing, the signal will turn. The crossing lights may begin flashing and the barriers lower immediately, or this might be delayed until after the traffic light turns red.
The operation of a traffic signal, while a train is present, may differ from municipality to municipality. There are a number of possible arrangements:
All directions will flash red, turning the intersection into anall-way stop.
While the train is passing, the traffic parallel to the railroad track will have a flashing yellow, while the other directions face a flashing red light.
While the train is passing, the traffic parallel to the railroad track will have a green light, while the other directions face a red light.
Traffic lights can operate relatively normally, with only the blocked direction turning red while the train is passing.
In France, cameras have been installed on some level crossings to obtain images to improve understanding of an incident when a technical investigation occurs.[17]
In England, cameras have been installed at some level crossings.[18][19]
In South Australia, cameras have been installed at some level crossings to deter non-compliance with signals.[20]
Level crossings present a significant risk of collisions between trains and road vehicles. This list is not a definitive list of the world's worst accidents and the events listed are limited to those where a separate article describes the event in question.
Crossing of theA970 road overSumburgh Airport's runway inShetland. The movable barrier closes when aircraft land or take off.The French sign warning of plane movements on or near the ground was changed in 1977 to comply with the Vienna convention.
Aircraft runways sometimes cross roads or rail lines, and require signaling to avoid collisions.
Sydney Airport had a runway crossing, when that runway was extended. ThePort Botany railway line was later deviated in March 1960 to release land for newQantas hangars with sharp curves that avoided the runway.[42][43] On 18 June 1950, aDouglas DC-3 operating forAnsett Australia was involved in a ground collision with a freight train at the crossing.[44] The accident derailed several train cars, severely damaged the aircraft, and resulted in one minor injury to the aircraft crew.[45]
Burnie Airport had a runway crossing over the 05/23 Runway. This crossing was built over the railway line when the airfield was constructed, and has since been decommissioned with the closing of both the railway line and the 05/23 runway.[46]
As of March 2023, a tunnel under the runway opened to regular traffic, and the level crossing will only be available to pedestrians, cyclists and e-scooters.[47]
After the runway ofKai Tak Airport was extended in 1943, it intersected with the easternmost section ofPrince Edward Road, so all road traffic had to be stopped during takeoffs and landings. The issue was relieved when the authorities constructed a new runway for replacement in September 1958.[48]
A train crosses the runway in Manakara, Madagascar.
The Fianarantsoa-Côte Est railway crosses the runway atManakara Airport. It is one of the few airports in the world that crosses an active railway line.
A level crossing nearGisborne, sees thePalmerston North - Gisborne Line cross one ofGisborne Airport'srunways. Aircraft landing on sealed 1310-metre runway 14L/32R are signalled with two red flashing lights on either side of the runway and a horizontal bar of flashing red lights to indicate the runway south of the railway line is closed, and may only land on the 866 metres (2,841 ft) section of the runway north of the railway line. When the full length of the runway is open, a vertical bar of green lights signal to the aircraft, with regular rail signals on either side of the runway indicating trains to stop.[49][50]
Northern Ireland: There was a runway crossing on theBelfast–Derry railway line. The runway was interlocked with conventional railway block instruments to the control tower.
^"RS 0.741.20 Convention du 8 novembre 1968 sur la signalisation routière (avec annexes)" [RS 0.741.20: Convention of 8 November 1968 on the road signals (with appendices)].Swiss Federal Government Portal (in French) (11 December 1992 ed.). Vienna. 29 December 2016 [1968]. Retrieved22 January 2019.Un feu rouge clignotant; ou deux feux rouges, clignotant alternativement, dont l'un apparaît quand l'autre s'éteint, montés sur le même support à la même hauteur et orientés dans la même direction signifient que les véhicules ne doivent pas franchir la ligne d'arrêt ou, s'il n'y a pas de ligne d'arrêt, l'aplomb du signal; ces feux ne peuvent être employés qu'aux passages à niveau [et dans certaines autres circonstances]...un feu jaune clignotant ou deux feux jaunes clignotant alternativement signifient que les conducteurs peuvent passer, mais avec une prudence particulière.
^abCirovic, G.; Pamucar, D. (2012). "Decision support model for prioritizing railway level crossings for safety improvements: Application of the adaptive neuro-fuzzy system".Expert Systems with Applications.40 (6):2208–2223.doi:10.1016/j.eswa.2012.10.041.
^rapport d'enquête technique sur la collision entre un train Transilien et un véhicule léger survenue le 15 septembre 2019 sur le passage à niveau n° 8 à Roissy-en-Brie (77)