 | This article has multiple issues. Please helpimprove it or discuss these issues on thetalk page.(Learn how and when to remove these messages) (Learn how and when to remove this message)
|
Aninterrupted screw orinterrupted thread is a mechanical device typically used in thebreech ofartillery guns. It is believed to have been invented in 1845.[1]
The system has also been used to close other devices, including the joint between helmet (bonnet) and breastplate (corselet) ofstandard diving suit helmets, and the locks ofdiving chambers.
An interrupted screw has a section of thread along its axis removed. The screw is mated with a partially threaded hole in the receptacle: threadless channels in the breechblock screw line up with the threaded parts of the receptacle, and vice versa. The screw can thus be smoothly inserted all the way into the receptacle, after which as little as one-eighth of a turn can engage the two sets of threads securely, sealing the joint.
The amount of rotation required to achieve full closure depends on the number of unthreaded sectors. The minimum balanced arrangement has two sectors of 90°, and requires 1/4 turn to lock. three sectors of 60° requires 1/6 turn to lock, and the typical arrangement on a diving helmet, four sectors of 45°, requires 1/8 turn to lock.[2]
In the artillery application, the screw is set into the breechblock and mated with a partially threaded hole at the rear of the weapon's chamber.
American engraver Benjamin Chambers, Sr.[3] received a patent[4] in 1849 for awrought ironbuilt-up gun "dissected screw breech" with "sectional screws" "cut therein for the purpose of speedily opening the breech for swabbing, depositing the load, and readily closing it again when the gun is to be discharged". His gun was built and tested with metallic cartridges, center-primed with apercussion cap, because theUS Navy was initially interested, and chief of theBureau of OrdnanceCharles Morris recommended more developments, but the system was too expensive for the time and cheaperDahlgren guns were adopted instead.[5]
Breech sealing was improved with thede Bange obturator in 1872, and all interrupted screw breeches with this system were generally known as the De Bange type.
The major weakness of the original designs was that only half of the circumference of the breechblock could be threaded, hence a fairly long breechblock was still required to achieve a secure lock.Axel Welin solved this problem with his stepped interrupted screw design: theWelin screw breech of 1890. This design has threads of the block and breech cut in steps of successively largerradius. For example, this allows a breech screw with three steps to allow three-quarters of the block circumference to be threaded, allowing for a much shorter breechblock while still requiring only one-quarter of a turn to open or close. This is the basic design still in use withbagged charge artillery.
Interrupted screws are occasionally seen in loose gunpowder rifles, as this mechanism was historically one of the few practical ways to achieve a gas-proof seal with a breech-loading firearm that does not employ metalliccartridges. An earlier method was the use of a wedge to block the rear of the gun.[1] The interrupted screw arrangement enables more precise and repeatable lock up in-battery position, increasing accuracy on high powered sniper rifles.[citation needed]
The system has also been used to close other applications, including the joint between helmet (bonnet) and breastplate (corselet) ofstandard diving suit helmets, and the locks ofdiving chambers.[citation needed]
