Development | |
---|---|
Designer | Mark Bremer |
Location | United States |
Year | 1995 |
Builder(s) | CW Hood Yachts/Bremer Marine |
Role | Racer-Cruiser |
Name | Bremer 25 |
Boat | |
Displacement | 3,800 lb (1,724 kg) |
Draft | 6.16 ft (1.88 m) with thelifting keel down |
Hull | |
Type | monohull |
Construction | fiberglass |
LOA | 25.00 ft (7.62 m) |
LWL | 22.50 ft (6.86 m) |
Beam | 8.00 ft (2.44 m) |
Engine type | outboard motor |
Hull appendages | |
Keel/board type | lifting keel |
Ballast | 1,600 lb (726 kg) |
Rudder(s) | transom-mountedrudder |
Rig | |
Rig type | Bermuda rig |
I foretriangle height | 31.70 ft (9.66 m) |
J foretriangle base | 8.50 ft (2.59 m) |
P mainsail luff | 30.70 ft (9.36 m) |
E mainsail foot | 11.40 ft (3.47 m) |
Sails | |
Sailplan | fractional riggedsloop |
Mainsail area | 174.99 sq ft (16.257 m2) |
Jib/genoa area | 134.73 sq ft (12.517 m2) |
Total sail area | 309.72 sq ft (28.774 m2) |
TheBremer 25 is an Americantrailerablesailboat that was designed byMark Bremer as aracer-cruiser and first built in 1995.[1][2]
The design was built byCW Hood Yachts forBremer Marine in theUnited States starting in 1995, but it is now out of production.[1][2]
The designer was abusiness consultant with anMBA, who wanted to design a production sailboat.[2]
The Bremer 25 is a recreationalkeelboat, built predominantly offiberglass. The hull and the deck are made fromvacuum-bagged biaxal fiberglass with a Core-Cell foam core. It has afractionalsloop rig, aplumb stem, a verticaltransom, a transom-hungrudder controlled by atiller and alifting keel. It displaces 3,800 lb (1,724 kg) and carries 1,600 lb (726 kg) of lead ballast in a swept bulb on the fiberglass keel.[1][2][3]
The boat has a draft of 6.16 ft (1.88 m) with the lifting keel extended and 2.50 ft (0.76 m) with it retracted, allowing ground transportation on atrailer.[1][2]
The boat is normally fitted with a small 4 to 6 hp (3 to 4 kW)outboard motor for docking and maneuvering.[1][2]
The design has sleeping accommodation for four people, with a small double "V"-berth in the bow cabin and an aft cabin with a large double berth. Thegalley is located on the port side just aft of the bow cabin. The galley is equipped with a stove and a sink. The main cabin has two small seats. The stand-uphead is located just aft of the bow cabin on the starboard side. Cabin headroom is 72 in (180 cm). The fresh water tank has a capacity of 3 U.S. gallons (11 L; 2.5 imp gal).[1][2]
The design has ahull speed of 6.4 kn (11.9 km/h).[2]
In a 2002 review Quentin Warren wrote inCruising World, "the Bremer favors the performance end of the pocket cruiser spectrum". In describing sailing it, he wrote, "true to form, the Bremer accelerated well, tracked like a monorail and stood up to any puffs. Response at the helm was instant and refined; reaction to subtle trim, noticeable and attentive. The jib on this boat features roller furling with the unit recessed into the bow, and this keeps the airflow attached down low on what is truly a deck-sweeper of a headsail. A deck-fitted sprit can be deployed from the cockpit by yanking on a clever tackle arrangement; off the breeze we launched an asymmetrical kite from the end of this and charged along in good control."[3]
In a 2010 review Steve Henkel wrote, "...how many 25-foot sleek-looking sport boats do you see with six-foot headroom? Or a double berth big enough to accommodate two full-sized adults? Or an enclosed stand-up head? Or a very deep keel with ballast of 1,600 pounds (42% B/D ratio) massed almost at its bottom? Best features: This boat has enough freeboard to make the cabin quite roomy. With her retractable keel, she shouldn't be too hard to launch and retrieve at a trailer ramp. And her trailer towing weight of just over 5,000 pounds is low enough to permit use of a variety of 20- to 30-year-old full-size cars equipped with towing packages to pull her over the road. Worst features: The forward berth would only be useful for two very small children or one small adult."[2]