 | This articleneeds additional citations forverification. Please helpimprove this article byadding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "Whip antenna" – news ·newspapers ·books ·scholar ·JSTOR(August 2013) (Learn how and when to remove this message) |
_closeup.jpg)
Awhip antenna is anantenna consisting of a straight flexible wire or rod. The bottom end of the whip is connected to theradio receiver ortransmitter. A whip antenna is a form ofmonopole antenna. The antenna is designed to be flexible so that it does not break easily. Whip antennas for portable radios are often made of a series of interlockingtelescoping metal tubes, so they can be retracted when not in use. Longer whips, made for mounting on vehicles and structures, are made of a flexiblefiberglass rod around a wire core and can be up to 11 m (35 feet) long.
The length of a whip antenna is determined by thewavelength of theradio waves it is used with. Their length varies from compactelectrically short antennas1/ 10 wavelength long, up to 5 /8 wavelength to improve directivity. The most common type is thequarter-wave whip, which is approximately 1 /4 wavelength long.
Whips are the most common type ofmonopole antenna, and are used in the higher frequencyHF,VHF andUHF radio bands. They are widely used as the antennas for hand-held radios,cordless phones,walkie-talkies,FM radios,boom boxes, andWi-Fi enabled devices, and are attached to vehicles as the antennas forcar radios andtwo-way radios for wheeled vehicles and for aircraft. Larger versions mounted on roofs, balconies and radio masts are used asbase station antennas foramateur radio and police, fire, ambulance, taxi, and other vehicle dispatchers.
The whip antenna is amonopole antenna, and like a vertical dipole has anomnidirectionalradiation pattern, radiating equal radio power in all azimuthal directions (perpendicular to the antenna's axis), with the radiated power falling off with elevation angle to zero on the antenna's axis.[1] Whip antennas less than one-half wavelength long, including the common quarter wave whip, have a singlemain lobe, and with a perfectly conducting ground plane under it maximum field strength is in horizontal directions, falling monotonically to zero on the axis. With a small or imperfectly conducting ground plane or no ground plane under it, the general result is to tilt the main lobe up so maximum power is no longer radiated horizontally but at an angle into the sky.
Antennas longer than a half-wavelength have patterns consisting of several conical "lobes"; with radiation maxima at several elevation angles; the longer theelectrical length of the antenna, the more lobes the pattern has.
A vertical whip radiatesvertically polarized radio waves, with theelectric field vertical and the magnetic field horizontal.
Vertical whip antennas are widely used fornondirectional radio communication on the surface of the Earth, where the direction to the transmitter (or the receiver) is unknown or constantly changing, for example in portableFM radio receivers,walkie-talkies, andtwo-way radios in vehicles. This is because they transmit (or receive) equally well in all horizontal directions, while radiating little radio energy up into the sky where it is wasted.
Whip antennas are normally designed asresonant antennas; the rod acts as aresonator for radio waves, withstanding waves of voltage and current reflected back and forth from its ends. Therefore, the length of the antenna rod is determined by thewavelength () of the radio waves used. The most common length is approximately one-quarter of the wavelength (), called a "quarter-wave whip" (although often shortened by the use of aloading coil; seeElectrically short whips below). For example, the common quarter-wave whip antennas used on FM radios in the USA are approximately 75 cm (2.5 feet) long, which is roughly one-quarter the length of radio waves in theFM radio band, which are 2.78 to 3.41 m (9 to 11 feet) long.
Half-wave whips ( long) which have greatergain, and five-eighth wave whips ( long) which have the maximum horizontal gain achievable by a monopole, are also common lengths.
The gain and input impedance of the antenna is dependent on the length of the whip element, compared to a wavelength, but also on the size and shape of the ground plane used (if any). A quarter wave vertical antenna working against a perfectly conducting, infinite ground will have a gain of 5.19 dBi and aradiation resistance of about 36.8 ohms. However this gain is never approached in actual antennas unless the ground plane is many wavelengths in diameter. 2 dBi is more typical for a whip with a ground plane of Whips mounted on vehicles use the metal skin of the vehicle as a ground plane. In hand-held devices usually no explicit ground plane is provided, and the ground side of the antenna'sfeed line is just connected to the ground (common) on the device's circuit board.[2] Therefore, the radio itself serves as a rudimentary ground plane. If the radio chassis is not a good deal larger than the antenna itself, the combination of whip and radio functions more as an asymmetricaldipole antenna than as amonopole antenna.[3][4] The gain will be somewhat lower than a dipole, or a quarter-wave whip with an adequate size ground plane.
Whips not mounted on the radio itself are usually fed withcoaxial cable feedline of 50 ohm or 75 ohm impedance. In transmitting antennas the impedance of the antenna must bematched to the feedline for maximum power transfer.
A half wave whip antenna (length of) has somewhat higher gain than a quarter wave whip, but it has a currentnode at its feedpoint at the base of the rod so it has very high input impedance. If it was infinitely thin the antenna would have an infinite input impedance, but the finite width gives typical, practical half wave whips an impedance of 800–1,500 ohms. These are usually fed through animpedance matching transformer or aquarter wave stub matching section (e.g. theJ-pole antenna). An advantage is that because it acts as a dipole it does not need a ground plane.
The maximum horizontal gain of a monopole antenna is achieved at a length of five eighths of a wavelength so this is also a popular length for whips. However at this length the radiation pattern is split into a horizontal lobe and a small second lobe at a 60° angle, so high angle radiation is poor. The input impedance is around 40 ohms.
In a whip antenna not mounted on a conductive surface, such as one mounted on a mast, the lack of reflected radio waves from the ground plane causes the lobe of the radiation pattern to be tilted up toward the sky so less power is radiated in horizontal directions, undesirable for terrestrial communication.[5] Also the unbalanced impedance of the monopole element causes RF currents in the supporting mast and on the outside of the ground shield conductor of the coaxial feedline, causing these structures to radiate radio waves, which usually has a deleterious effect on the radiation pattern.
To prevent this, with stationary whips mounted on structures, an artificial "ground plane" consisting of three or four rods a quarter-wavelength long connected to the opposite side of the feedline, extending horizontally from the base of the whip, is often used.[5] This is called aground plane antenna.[6] These few short wire elements serve to receive thedisplacement current from the driven element and return it to the ground conductor of the transmission line, making the antenna behave somewhat as if it has a continuous conducting plane under it.
The radiation resistance of a quarter wave ground plane antenna with horizontal ground wires is around 22 ohms, a poor match tocoaxial cable feedline, and the main lobe of the radiation pattern is still tilted up toward the sky. Often(see pictures) the ground plane rods are sloped downward at a 45-degree angle, which has the effect of lowering the main lobe of the radiation pattern so more of the power is radiated in horizontal directions, and increases the input impedance for a good match to standard 50-ohmcoaxial cable. To match 75-ohm coaxial cable, the ends of the ground plane can be turned downward or a folded monopole driven element can be used.
To reduce the length of a whip antenna to make it less cumbersome, aninductor (loading coil) is often added in series with it. This allows the antenna to be made much shorter than the normal length of a quarter-wavelength, and still beresonant, by cancelling out thecapacitive reactance of the short antenna. This is called anelectrically short whip. The coil is added at the base of the whip (called a base-loaded whip) or occasionally in the middle (center-loaded whip). In the most widely used form, therubber ducky antenna, the loading coil is integrated with the antenna itself by making the whip out of a narrowhelix of springy wire. The helix distributes the inductance along the antenna's length, improving the radiation pattern, and also makes it more flexible. Another alternative occasionally used to shorten the antenna is to add a "capacity hat", a metal screen or radiating wires, at the end. However all theseelectrically short whips have lowergain than a full-length quarter-wave whip.
Multi-band operation is possible with coils at about one-half or one-third and two-thirds that do not affect the aerial much at the lowest band, but it creates the effect of stacked dipoles at a higher band (usually ×2 or ×3 frequency).
At higher frequencies[a]the feed coax can go up the centre of a tube. The insulated junction of the tube and whip is fed from the coax and the lower tube end where coax cable enters has an insulated mount. This kind of vertical whip is a full dipole and thus needs no ground plane. It generally works better several wavelengths above ground, hence the limitation normally to microwave bands.
